Parts for Ge CSB48WSKBSS: Freezer Section Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

Fix uneven cooling or defrost issues with a new temperature sensor. Most DIYers complete this repair in under an hour with basic tools and our video.

Secures and seals water line connections in your refrigerator's dispensing system. Replace if leaking or loose to prevent water damage. Confirm fit.

Fix frost buildup and temperature fluctuations in your refrigerator. This defrost heater melts ice from evaporator coils during the defrost cycle. Moderate DIY.

Fix a refrigerator that's not cooling properly or has excessive frost buildup with this evaporator coil. Handles heat removal in side-by-side models.

Fix water pooling under your refrigerator with this drain pan and heater assembly. Collects condensation and prevents freezing in cold environments.

This wiring harness connects the freezer compartment's components to the appliance's electrical system, restoring reliable power and signal paths so fans, lights, and controls operate as intended. What it does:

• Provides secure electrical connections between freezer components and the main wiring loom.
• Replaces damaged or corroded wiring that can cause intermittent or complete loss of power to freezer parts.
• Helps stop symptoms like non-running evaporator fans, inoperative interior lights, or other freezer electrical failures.
• Maintains proper connector fit and routing to prevent chafing and short circuits.

• Disconnect power to the appliance before starting any repair.
• Inspect connectors and mating terminals for damage; replace any corroded terminals.
• Route and secure the harness to avoid heat sources, moving parts, and pinch points.

LED tower assembly illuminates your refrigerator interior. Replace when lights flicker, dim, or fail completely. Verify fit with your model number.

Flexible drain tube that routes defrost water from the evaporator to the drain pan. Replace if cracked, split, clogged, or missing to prevent leaks.

Refrigerator not cooling or freezing over? This defrost thermostat sensor regulates defrost cycles to prevent frost buildup and maintain proper temperature.

Rubber bumper that cushions and mounts the evaporator fan motor assembly. Replace if cracked, deteriorated, or missing to reduce vibration and noise.

Mounting screw for refrigerator interior components and panels. Replace if stripped, missing, or damaged during service to secure parts properly.

Fix loud fan noise and poor cooling with a new evaporator fan blade. Restores airflow across coils. Moderately difficult install in tight freezer space.

If your refrigerator compartment isn't cooling while the freezer stays cold, the evaporator fan motor likely failed. DIY-friendly repair with video guide.

Secures the evaporator fan motor to the refrigerator cabinet. Replace if your original bracket is bent, broken, or cracked to restore proper mounting.

Secures the evaporator fan shroud to the rear compartment frame. Replace if rusted, cracked, or broken to properly support the fan assembly and alignment.

Rubber grommet that seals and cushions where the evaporator fan motor shaft mounts. Replace if cracked, worn, or missing to eliminate noise and vibration.

Fix ice buildup on evaporator coils with this defrost thermostat. Monitors coil temperature to signal defrost cycles. Test for continuity when frozen.

Secures the defrost heater assembly in your refrigerator's freezer section. Replace if the original bracket is cracked, broken, or missing.

Replacement edge trim that covers and protects exposed edges on refrigerator doors or cabinets. Needed when original trim is cracked, broken, or missing.