Parts for Ge PSB42YSKCSS: Freezer Section Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

Fix uneven cooling or defrost issues with a new temperature sensor. Most DIYers complete this repair in under an hour with basic tools and our video.

Secures and seals water line connections in your refrigerator's dispensing system. Replace if leaking or loose to prevent water damage. Confirm fit.

Fix frost buildup and temperature fluctuations in your refrigerator. This defrost heater melts ice from evaporator coils during the defrost cycle. Moderate DIY.

Fix a refrigerator that's not cooling properly or has excessive frost buildup with this evaporator coil. Handles heat removal in side-by-side models.

This foam block fits around the refrigerator evaporator to insulate and stabilize the evaporator assembly, helping reduce vibration and limit unwanted air flow for more consistent cooling performance. What it does

• Provides cushioning and vibration dampening for the evaporator assembly.
• Helps seal gaps around the evaporator to support proper airflow and temperature control.
• Reduces rattle and noise caused by contact between the evaporator and surrounding cabinet parts.
• Supports correct evaporator placement to prevent ice buildup from air leaks.

• Disconnect power to the appliance before starting any repair.
• Handle the foam gently to avoid tearing; position it as shown in the evaporator area or OEM diagram.
• Use only OEM-recommended clips or fasteners; do not rely on solvents or non-approved adhesives unless specified by the manufacturer.

Fix water pooling under your refrigerator with this drain pan and heater assembly. Collects condensation and prevents freezing in cold environments.

LED tower assembly illuminates your refrigerator interior. Replace when lights flicker, dim, or fail completely. Verify fit with your model number.

Flexible drain tube that routes defrost water from the evaporator to the drain pan. Replace if cracked, split, clogged, or missing to prevent leaks.

Refrigerator not cooling or freezing over? This defrost thermostat sensor regulates defrost cycles to prevent frost buildup and maintain proper temperature.

Rubber bumper that cushions and mounts the evaporator fan motor assembly. Replace if cracked, deteriorated, or missing to reduce vibration and noise.

Mounting screw for refrigerator interior components and panels. Replace if stripped, missing, or damaged during service to secure parts properly.

Fix loud fan noise and poor cooling with a new evaporator fan blade. Restores airflow across coils. Moderately difficult install in tight freezer space.

If your refrigerator compartment isn't cooling while the freezer stays cold, the evaporator fan motor likely failed. DIY-friendly repair with video guide.

Secures the evaporator fan motor to the refrigerator cabinet. Replace if your original bracket is bent, broken, or cracked to restore proper mounting.

Secures the evaporator fan shroud to the rear compartment frame. Replace if rusted, cracked, or broken to properly support the fan assembly and alignment.

Rubber grommet that seals and cushions where the evaporator fan motor shaft mounts. Replace if cracked, worn, or missing to eliminate noise and vibration.

Fix ice buildup on evaporator coils with this defrost thermostat. Monitors coil temperature to signal defrost cycles. Test for continuity when frozen.

Secures the defrost heater assembly in your refrigerator's freezer section. Replace if the original bracket is cracked, broken, or missing.

Replacement edge trim that covers and protects exposed edges on refrigerator doors or cabinets. Needed when original trim is cracked, broken, or missing.