Parts for Hot Point HPS16BTNBRBB: Freezer Section Parts

Fix excessive frost buildup in your freezer with this defrost heater assembly. Melts ice from evaporator coils during defrost cycles. DIY-friendly repair.

This foam air actuator controls airflow for the appliance's foam/dispensing system, restoring proper air routing so the dispenser and foam-generation components work reliably. Replacement helps eliminate inconsistent foam delivery and related dispenser issues. What it does:

• Opens and closes the air path used by the foam/dispensing system to direct airflow where needed
• Helps maintain consistent foam production and dispensing performance
• Commonly replaced when foam dispensing is weak, intermittent, or not working
• Small electromechanical/plastic actuator piece that responds to control signals

• One foam air actuator

• Disconnect power to the appliance before replacing to avoid shock or damage
• Access may require removing the dispenser or inner cabinet panels
• Handle plastic actuator parts carefully to avoid breaking clips or mounting tabs

Wire shelf for refrigerator freezer compartment. Replace bent, rusted, or missing shelves to restore storage capacity and keep frozen items organized.

This fill tube port cover replaces the plastic trim that secures and protects the ice maker fill tube where it passes through the refrigerator liner, helping keep the fill tube aligned and reducing leaks or rattle noise. What it does:

• Secures the ice maker water fill tube in the cabinet wall to keep the tube properly positioned
• Helps prevent water spray or leaks at the fill tube entry point
• Reduces vibration and rattling caused by a loose or damaged port trim
• Restores a finished appearance around the fill tube opening

• One fill tube port cover

• Disconnect power to the refrigerator before starting any work
• Shut off the water supply and drain any residual water from the fill tube to avoid spills
• Usually installs with snap-fit tabs; gently pry out the old trim and press the new cover into place
• After installation, restore power and water, then observe one ice/ fill cycle to ensure proper operation

Fixes noisy fan, ice buildup, or warm fridge temps. This evaporator fan motor circulates cold air between compartments. DIY-friendly repair, 1 hour.

Refrigerator not cooling evenly or making noise? The evaporator fan blade circulates cold air. Simple press-on installation in under 30 minutes.

The Lid Bumper is an OEM part for GE refrigerators. It is designed to provide cushioning and protection for the refrigerator lid, preventing damage and ensuring smooth, quiet closing. 

Causes of a bad Lid Bumper can include deterioration over time due to frequent use, exposure to temperature variations, or damage from accidental impacts. A worn or damaged bumper may no longer provide adequate cushioning, leading to potential damage to the lid or the refrigerator itself.

Symptoms of a bad Lid Bumper include:

• The refrigerator lid closing too hard
• Unusual noises when closing the lid
• Visible wear or cracks on the bumper

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Rubber grommet that seals and cushions where the evaporator fan motor shaft mounts. Replace if cracked, worn, or missing to eliminate noise and vibration.

Fix loose or rattling evaporator coils with this refrigerator evaporator clip. Secures evaporator assembly in place. Simple snap-in installation.

Replacement drain trough for your refrigerator's defrost system. Collects and channels water to the drain tube. Replace if cracked, broken, or missing.

Hex washer head screw for refrigerators. Secures internal components and panels. Replace if stripped, missing, or damaged during repairs.

Hex washer head screw for refrigerator assembly. Secures internal components like fan housings and panels. Replace if stripped, missing, or damaged.

Mounts the evaporator fan assembly inside the freezer compartment. Replace if cracked, broken, or damaged from repeated fan motion or temperature stress.

Secures brackets, panels, and internal components in your refrigerator. Replace missing or damaged screws to eliminate rattles and keep parts aligned.