Parts for Ge PDSF5NBXBBB: 03 - Freezer Shelves Parts

8-18 CA HX 1/2 S

This silicon controlled rectifier (SCR) is an electronic switching device used to control power to oven/stove heating circuits, helping the appliance regulate temperature and heat output for cooking performance. What it does:

• Switches and regulates AC power to heating elements for controlled heat
• Enables cycle-based or phase-controlled heating used by oven/range controls
• Common replacement when an element won't heat consistently or unit won't maintain temperature
• Helps stop erratic heating caused by a failed power control component

• Disconnect power to the appliance before inspecting or replacing the SCR
• Observe ESD precautions and handle the component by insulated edges

This upper drawer slide assembly supports and guides a refrigerator bin beneath its shelf. Replacing a cracked or worn slide restores smooth, aligned drawer movement so the bin opens and closes easily without binding or sagging.

• Provides the track the drawer rides on under the shelf
• Keeps the drawer level and properly aligned for smooth operation
• Typical failure signs: hard-to-open/close drawer, scraping, falling off track, visible cracks
• Helps prevent drooping on one side and restores stable support

• Unplug the refrigerator before servicing.
• Remove the drawer and any contents; handle glass shelves carefully if removal is required.
• Retain and reuse original screws/fasteners or trim pieces.
• Ensure the new slide is fully seated and level before reinstalling the drawer.

This right-side rail holder secures the refrigerator door/organizer rail to the liner, keeping shelves and bins stable for reliable storage. It replaces a cracked or broken holder to restore proper fit and alignment. What it does:

• Secures the rail/organizer to the cabinet liner so door bins and rails stay in place
• Prevents rail sagging, misalignment, or rails coming loose during use
• Restores proper rail fit when the original holder is cracked, broken or worn
• Works with the corresponding left-side holder to support the full rail assembly

• Disconnect power to the appliance before beginning work to avoid electrical hazards
• Remove door bins/rails or inner liners as needed to access the holder; handle glass or plastic shelves carefully
• Install with the correct orientation (right-side) and secure fasteners snugly without over-tightening
• If the mating rail or mounting area is damaged, inspect and repair those parts before reinstalling