Parts for Ge PFSS2MJYCSS: 03 - Freezer Shelves Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

8-18 CA HX 1/2 S

This silicon controlled rectifier (SCR) is an electronic switching device used to control power to oven/stove heating circuits, helping the appliance regulate temperature and heat output for cooking performance. What it does:

• Switches and regulates AC power to heating elements for controlled heat
• Enables cycle-based or phase-controlled heating used by oven/range controls
• Common replacement when an element won't heat consistently or unit won't maintain temperature
• Helps stop erratic heating caused by a failed power control component

• Disconnect power to the appliance before inspecting or replacing the SCR
• Observe ESD precautions and handle the component by insulated edges

This silicon controlled rectifier (SCR) is a replacement control semiconductor that helps regulate power to heating elements and motors, restoring proper cycle control and heat delivery in compatible appliances. What it does:

• Controls and chops AC power to heating elements or motor circuits for variable heat/speed control
• Can stop intermittent or no-heat conditions caused by a failed SCR in oven, range, or similar appliances
• Helps restore stable thermostat/regulation behavior when the original SCR is not switching correctly
• Commonly used where precise power control is required in the appliance's control board or module

• One silicon controlled rectifier (SCR) as shown

• High-level, service-only replacement — disconnect power before starting work
• Verify correct part number on the appliance and transfer heat sinks or mounting hardware if required
• Use proper ESD precautions when handling semiconductor components

This upper drawer slide assembly supports and guides a refrigerator bin beneath its shelf. Replacing a cracked or worn slide restores smooth, aligned drawer movement so the bin opens and closes easily without binding or sagging.

• Provides the track the drawer rides on under the shelf
• Keeps the drawer level and properly aligned for smooth operation
• Typical failure signs: hard-to-open/close drawer, scraping, falling off track, visible cracks
• Helps prevent drooping on one side and restores stable support

• Unplug the refrigerator before servicing.
• Remove the drawer and any contents; handle glass shelves carefully if removal is required.
• Retain and reuse original screws/fasteners or trim pieces.
• Ensure the new slide is fully seated and level before reinstalling the drawer.

Sheet metal screw secures refrigerator panels, trim, and brackets. Replace missing, stripped, or corroded screws to restore proper fit and assembly.