Parts for Magic Chef CTF1925GRQ: 10 - Fresh Food Outer Door (Rev.12) Parts

A small replacement screw used to secure appliance panels and components so assemblies stay aligned and stable during normal use. Simple, direct fix for loose trim, panels, or mounting points. What it does:

• Secures panels, brackets, or small components to prevent rattling and movement
• Restores proper alignment where a missing or damaged fastener causes gaps
• Helps stop vibration-related noise from loose parts
• Functions as the original-style fastener matching OEM fit and purpose

• Disconnect power and water to the appliance before servicing where applicable
• Use the correct screwdriver or bit to avoid stripping the head
• Thread the screw in by hand to start, then tighten snugly—do not over-torque
• Keep removed hardware organized and compare sizes before installing

This lower hinge pin is the pivot shaft for your refrigerator door. Replacing a worn or bent pin restores smooth movement and proper alignment so the door seals and closes correctly while reducing hinge noise.

• Serves as the pivot point between the door and the lower hinge bracket
• Helps maintain door height and alignment for an even gasket seal
• Wear or damage can cause door sagging, rubbing, squeaking, or inconsistent closing
• Replacing the pin can restore smooth swing and reduce wobble at the hinge

• Disconnect power; remove items from the door. Support the door and remove the upper hinge to lift the door off the lower hinge.
• Replace the lower hinge pin on the hinge/bracket, reusing any model-specific washers or bushings.
• Reinstall, level, and align the door so the gasket seals evenly; verify smooth swing and positive closure.

This hinge supports and pivots the washer lid so it opens and closes smoothly. Replacing a worn or broken hinge restores proper alignment and helps the lid close securely without binding or rubbing.

• Provides the pivot point for the lid to open and close
• Keeps the lid aligned with the top panel
• Wear symptoms include wobble or sagging, squeaks, binding, or visible cracks/bending
• Misalignment may prevent the lid switch/latch from engaging properly

• Unplug the washer before servicing; have a helper support the lid
• Remove the mounting screws, noting hinge orientation for reassembly
• Transfer and reuse original screws/trim as applicable; do not overtighten
• Test lid alignment and operation before fully tightening the fasteners