Parts for Ge CFE28TP2MIS1: Fresh Food Section Parts

Hex washer head screw for refrigerators. Secures internal components and panels. Replace if stripped, missing, or damaged during repairs.

This selector control provides the hi/lo switching function for the oven/range heating circuit, restoring user control over high and low heat settings. It replaces a failed selector so the range can select the proper heat level reliably. What it does:

• Switches between high and low heat settings for the heating element or burner
• Restores control when heat setting changes do not respond or stick
• Helps eliminate intermittent or no-heat conditions caused by a worn selector
• Matches OEM function and mounting for a direct replacement

• One selector control assembly as shown

• Disconnect power to the appliance before starting any repair
• Handle electrical connections carefully; note wire locations or take a photo before removal
• Use basic hand tools; do not force connectors or mounting tabs

Adhesive foam gasket that seals gaps between panels and components to reduce air leaks and vibration. Replace when worn or compressed to restore efficiency.

Seals fresh food fan assembly to housing for proper airflow and temperature stability. Replace if damaged to reduce noise and vibration. Confirm fit.

The Refrigerator Fan Motor is an OEM replacement part for GE refrigerators. It circulates chilled air within the main cavity and fresh food compartment to maintain even cooling temperatures for foods. Proper airflow is critical for energy efficiency as well as preserving the freshness and longevity of stored items.

Causes of a bad fan motor include failure of the electrical components or motor bearings over many years of operation. Dust buildup may also slow airflow and result in overworking the motor.

Symptoms of a bad fan motor involve:

• Temperature fluctuations between sections of the refrigerator
• Frost or condensation building up quicker than expected
• Louder buzzing or grinding noises coming from inside the back wall

This genuine GE OEM replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Fix uneven cooling or defrost issues with a new temperature sensor. Most DIYers complete this repair in under an hour with basic tools and our video.

Air tower assembly that installs in the fresh food compartment to distribute cold airflow across shelves and bins. Replace if cracked or broken.

This center track screw cover caps the exposed screw on the center track assembly to protect the screw head and give the track a finished appearance. It helps reduce debris buildup and prevents accidental snags on the screw head. What it does:

• Covers and protects the center track screw head from dirt, moisture, and surface wear
• Helps maintain a smooth surface on the track to reduce snagging or catching
• Restores the OEM appearance where the original cap is missing or damaged
• Small replacement part used with center track assemblies and trim pieces

• One center track screw cover (cap)

• Designed for simple push- or snap-fit installation over the exposed screw head
• Remove power to the appliance before accessing internal trim or track areas, and follow manufacturer safety guidance
• If screw or track is damaged, inspect and replace the underlying hardware before installing the cap
• Handle small parts carefully to avoid loss during installation

Fix water pooling in your freezer with a new evaporator drain trough. Channels defrost water away from the freezer compartment to prevent leaks.

Fix frost buildup and uneven cooling in your bottom-mount refrigerator. This defrost heater assembly restores normal defrost cycles. Moderate DIY repair.