Frigidaire Cooktop Parts

Burner won't heat or randomly stays on? This range heating element restores proper burner function. DIY repair takes about 30 minutes with basic tools.

Medium burner crown for gas cooktops and ranges. Sits atop the burner base to shape and distribute flame. Replace if cracked, chipped, or damaged.

Burner won't heat or turn off? This infinite switch controls surface element temperature. Common fix when a burner stops working after replacing the element.

Range burner not heating or temperature won't adjust? This surface element control switch regulates heat output. Moderate DIY repair in 30-45 minutes.

Replace your cracked, broken, or damaged range glass cooktop. This smoothtop assembly installs on top of the stove to protect interior wiring and elements.

Black glass smooth top cooking surface for electric and gas ranges. Replaces cracked, chipped, or shattered cooktop glass to restore a safe surface.

Burner not heating or heating unevenly? This heating element restores proper heat output on electric ranges and cooktops. Direct replacement part.

This ignitor orifice assembly routes gas to the oven igniter so burners light reliably. It replaces a damaged or clogged orifice to restore consistent ignition and safe burner operation. What it does:

• Directs gas flow from the manifold to the igniter/pilot so the burner can light
• Helps restore proper ignition when the burner sparks but fails to light
• Replaces corroded, clogged, or damaged orifice hardware that can weaken flame
• Works with standard oven/range ignition systems that use a separate orifice assembly

• One ignitor orifice assembly

• Turn off gas supply and disconnect power before attempting service
• Basic hand tools required; avoid overtightening fittings to prevent damage
• Check for gas leaks with a non-corrosive leak detector after installation

Oven overheating or won't heat properly? This safety thermostat monitors backguard temperature to prevent overheating. Simple DIY fix restores safe operation.

This wiring harness routes power and signals between the appliance's control and various electrical components, restoring reliable electrical connections and helping the appliance operate as designed. Use it when wiring is damaged, corroded, or intermittent. What it does:

• Delivers power and signal paths between control boards, switches, and motors
• Restores lost or intermittent electrical connections that can cause failure to start or run
• Replaces burned, frayed, or broken wires and damaged connector terminals
• Helps eliminate arcing, shorts, and communication errors caused by faulty wiring

• Always disconnect all power (unplug or shut off breaker) before starting repairs
• Match connectors and wire routing to the original harness; avoid stretching or pinching wires
• Inspect mating connectors and terminals for damage before installation; replace any damaged parts
• If connectors are tight or corroded, clean or replace them rather than forcing connections

Replace a cracked, worn, or missing control knob on your electric cooktop. This single knob fits standard control stems for smooth burner adjustments.