Helmut D Rancho Palos Verdes , CA April 20, 2020 Appliance: Electrolux Washer EIFLW55HMB0 E21 water not pumping out fast enough (eiflw55hmb washer) Replaced pump. All components are accessible from the front of the machine. You have to remove two screws in the back that hold on the top cover, then slide the cover back. This will allow access to the screws that hold on the control panel. Remove the control panel (unplug cable), then remove the spring/wire that holds on the door bellows to the front panel (removing and installing that is the most difficult part of the job) and carefully remove the bellows from the front panel. Then remove the screws holding on the front panel and carefully remove the front panel. You can now see all the components. My machine was 10 years old, so I also decided to replace the tub-to-pump hose, and the door bellows seal as well as the drum dampener pins and two of the dampeners. When replacing the bellows, also ordered the back spring and the front spring/wire, mine were badly rusted. There are several YouTube videos that show how to remove the front of the machine (look up Electrolux door seal (or bellows) replacement). Note, my front panel was attached with square drive screws. You can get those bits at most home centers. If your machine is older, I recommend opening the machine before ordering any parts, so you can see if you will require any additional parts to repair other worn components. The actual pump replacement is easy. The door bellows and spring re-installation is the most challenging part of the job. Read More... 21 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers
Joe F Cary , NC October 25, 2014 Appliance: Electrolux Washer EIFLW55HIW0 Electrolux front load washer leaking water onto floor Replaced main coin strainer hose assembly (due to tear in outlet hose) Read More... 12 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Adjustable Wrench, Nut Drivers, Pliers, Screwdrivers, Socket Set
William P Hilbert , WI February 26, 2016 Appliance: Model FRIGIDARE Pump hose on bottom of washer had a hole in it I did not, but our sad repair place could not get the part for over a week, saw this company (first time) and looked up part, ordered and got it the next day. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours
Michael R Bainbridge Island , WA March 26, 2017 Appliance: Model EIFS55IIWO Had to replace this hose (pictured) A relatively easy fix, BUT..., if you do not get the wide opening on exactly right, it will leak and you'll have to redo. You have to push it up as far as it goes and hold it while you tighten the clamp. Do this 1st before attaching the smaller hoses and tightening the 2 smaller clamps. This job took more than an hour because I first had to remove a door and move a refrigerator and dryer out of a very small room Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Pliers
Harold G Luxemburg , WI July 21, 2017 Water leak under infinity washer Replaced drain pump hose Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers