Roxana N Stevenson Ranch , CA January 27, 2017 Ice maker made a knocking noise Had it replaced before by a technician so this time thought I could do it. Changed the part and it worked! Yay! Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers, Wrench Set
Tim F Pensacola , FL January 24, 2019 Appliance: Electrolux Refrigerator EW28BS70IB0 Refrigerator doors don’t close properly, due to the peg and magnet breaking off the top of the mid door flapper. Replaced part. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Joanne V Cranston , RI July 04, 2021 Pin snapped on the door mullion Got a new door mullion in one day. Replaced it in 5 minutes and it worked perfectly! Very satisfied. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Scott M Valparaiso , IN October 04, 2020 Broken mullion assembly (door flapper) Replaced assembly with a new part. Magnets in the new part are very weak, so had to remove magnets from the old assembly to use in the new assembly. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Michael H San Diego , CA March 26, 2022 The divider between the French doors broke it was the pin at the top. Suddenly my refrigerator doors would not close. I thought I had something inside the refrigerator that was blocking the door. But, when I looked, I noticed that the top pin on the divider between the French doors had broken and this is what blocked the door. The top pivot pin had broken off. This looked pretty serious and I was thinking I might need to disassemble the interior of the door to replace it. But, it was an easy fix. I found the part on AppliancePartsPros.com. My go-to repair part source. The part is called a Mullion Assembly with Heater. I had to look up Mullion to determine that it was the correct part. The heater also confused me. I did not see any wires or a heater. So, I removed the old one to take a look. Once you remove one screw, the part lifts off its hinge pins. Pull it away from the door frame, and sure enough, there is a wire. Put the door back together and ordered the new part. Removed that one screw again disconnected the wire, removed the old one and installed the new one. Very easy to fix. This part also has some very strong magnets that hold it closed. The assembly had the heater, the wire/connector, and the magnets. One part and one screw and it is fixed. I always count on AppliancePartsPros.com. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers