Parts for Ge DPXH46EF0CC: 02 - Front Panel & Door Parts

This wiring clip secures a wire harness to the appliance frame to prevent chafing and strain on electrical connections, helping maintain reliable operation and reduce the risk of wire damage. It's a small but important retainer used where wires need organization and relief. What it does:

• Holds wiring or harness in place to prevent rubbing against sharp edges or moving parts
• Reduces strain on terminals and connectors to help prevent loose connections or intermittent electrical faults
• Keeps routing tidy for safer, more reliable operation and easier servicing
• Useful when replacing worn, broken, or missing wire retainers that allow harness movement

• One wiring clip (quantity: 1)

• Disconnect power to the appliance before servicing to avoid shock or injury
• Position wiring as routed in the OEM diagram, then snap clip into the designated hole or stud until it seats securely
• Inspect surrounding insulation and connectors while installing; replace any damaged wires or terminals
• No special tools required for most installs; pliers may help align the clip if access is tight

White

Color: white. Measures about 12 inches wide by 7-1/2 inches high.

This replacement part is a guide clip, and it is intended for use in different types of appliances. This is a genuine replacement part made by General Electric. This guide clip is typically found on dryers, and there are usually multiple clips on one appliance to ensure the panels are secure. These clips help hold the front panel in place and secure so that it does not come off during the drying cycle and the machine sometimes shakes. A new guide clip might be needed if the front panel of the dryer is off balance or not attached correctly. It is possible that the clips can become loose over time or during transport if the appliance was banged or damaged. The clips are important as it keeps the dangerous parts covered and away from people who can become injured. If the entire front panel can be lifted off then it is time to replace the guide clips. These clips are sold individually even though dryers typically have more than one. This clip is a genuine OEM part.

This air duct directs cold air through the refrigerator compartment to maintain even cooling and improve temperature consistency. It replaces a damaged or missing duct to restore proper airflow and help prevent uneven cooling. What it does:

• Channels cold air from the evaporator into the fresh food compartment
• Prevents air leaks that can cause warm spots or frost buildup
• Helps maintain consistent internal temperatures for food safety
• Restores intended airflow after cracks, breaks, or distortion

• One replacement air duct

• Disconnect power to the appliance before beginning service
• Remove any shelves or panels that block access to the duct area
• Align duct tabs and secure with the original fasteners; replace damaged clips if needed

White

White

Color: clear. It's 7 watts 130 volts.