Parts for Ge DSXH43GF0WW: 02 - Front Panel & Door Parts

White dome plug insert for dryer control panel or cabinet. Replaces cracked, broken, or missing plastic dome plugs. Snaps into place to cover holes.

This wiring clip secures a wire harness to the appliance frame to prevent chafing and strain on electrical connections, helping maintain reliable operation and reduce the risk of wire damage. It's a small but important retainer used where wires need organization and relief. What it does:

• Holds wiring or harness in place to prevent rubbing against sharp edges or moving parts
• Reduces strain on terminals and connectors to help prevent loose connections or intermittent electrical faults
• Keeps routing tidy for safer, more reliable operation and easier servicing
• Useful when replacing worn, broken, or missing wire retainers that allow harness movement

• One wiring clip (quantity: 1)

• Disconnect power to the appliance before servicing to avoid shock or injury
• Position wiring as routed in the OEM diagram, then snap clip into the designated hole or stud until it seats securely
• Inspect surrounding insulation and connectors while installing; replace any damaged wires or terminals
• No special tools required for most installs; pliers may help align the clip if access is tight

This adhesive felt strip seals the gap between your dryer drum and the front panel. It prevents hot air from escaping and lint from building up in unwanted areas. Replace it if you notice excessive lint around the door area or reduced drying efficiency.

White

Color: white. Measures about 12 inches wide by 7-1/2 inches high.

This replacement part is a guide clip, and it is intended for use in different types of appliances. This is a genuine replacement part made by General Electric. This guide clip is typically found on dryers, and there are usually multiple clips on one appliance to ensure the panels are secure. These clips help hold the front panel in place and secure so that it does not come off during the drying cycle and the machine sometimes shakes. A new guide clip might be needed if the front panel of the dryer is off balance or not attached correctly. It is possible that the clips can become loose over time or during transport if the appliance was banged or damaged. The clips are important as it keeps the dangerous parts covered and away from people who can become injured. If the entire front panel can be lifted off then it is time to replace the guide clips. These clips are sold individually even though dryers typically have more than one. This clip is a genuine OEM part.

Fix uneven drying or poor airflow with this dryer air duct. Directs heated air through drum for consistent results. DIY-friendly installation.

Door hinge for dryers. Attaches the door to the dryer cabinet frame, allowing it to open and close smoothly. Replace if cracked, broken, or worn.

White

White

Color: clear. It's 7 watts 130 volts.

Dryer drum light bulb assembly illuminates the interior during operation. Replace when bulb burns out or light stops working. Verify fit with your model.