Parts for Ge DBL333EB0CC: 02 - Front Panel & Lint Filter Parts

Seals the unused drum light opening in your dryer cabinet. Replace if missing, cracked, or brittle to contain lint and protect internal components.

Secures and organizes wiring harnesses inside your dryer. Replace if wires are loose, vibrating, or damaged. Confirm fit with your model number.

The Drum Slide is an OEM replacement part for GE clothes dryers. It supports the front of the dryer drum, allowing it to rotate smoothly and quietly. Made of durable materials, this component reduces friction as the drum spins, ensuring that the appliance operates with minimal noise and wear.

Causes for a malfunctioning Drum Slide can include wear and tear from the constant rotation of the drum, accumulation of lint or debris causing friction, or damage due to overloading the dryer may also disrupt slide movement quality over time.

Symptoms of a faulty drum slide include:

• Noisy or off-balance drying
• Excessive drying times from inadequate tumbling action
• Premature wear of bearings and drive components due to slide friction issues

This GE OEM replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Color: white. Measures about 12 inches wide by 7-1/2 inches high.

This replacement part is a guide clip, and it is intended for use in different types of appliances. This is a genuine replacement part made by General Electric. This guide clip is typically found on dryers, and there are usually multiple clips on one appliance to ensure the panels are secure. These clips help hold the front panel in place and secure so that it does not come off during the drying cycle and the machine sometimes shakes. A new guide clip might be needed if the front panel of the dryer is off balance or not attached correctly. It is possible that the clips can become loose over time or during transport if the appliance was banged or damaged. The clips are important as it keeps the dangerous parts covered and away from people who can become injured. If the entire front panel can be lifted off then it is time to replace the guide clips. These clips are sold individually even though dryers typically have more than one. This clip is a genuine OEM part.

Fix uneven drying or poor airflow with this dryer air duct. Directs heated air through drum for consistent results. DIY-friendly installation.

Door hinge for dryers. Attaches the door to the dryer cabinet frame, allowing it to open and close smoothly. Replace if cracked, broken, or worn.

White

This control console plug is a small replacement wire connector that restores a secure electrical connection at the appliance control console, helping restore reliable console function and user controls. What it does

• Reconnects control console wiring to the console board, maintaining signal and power continuity
• Can resolve intermittent or lost console/display operation caused by a damaged or loose connector
• Provides the OEM-matching fit and terminal alignment for proper mating with the control board
• Useful when the original plug shows corrosion, bent terminals, or broken housing

• One control console plug (wire connector) as shown

• High-level replacement: access the console panel and unplug the old connector before installing the new one
• Disconnect power at the breaker or unplug the appliance before starting any work
• Verify connector orientation and fully seat until it clicks; avoid forcing pins to prevent damage