Parts for Bosch WTVC533CUS/11: Front Panel Parts

This is a factory-style screw used to secure appliance panels and components for a reliable, low-profile hold. It replaces worn or missing fasteners to stop rattling and keep parts aligned during normal use. What it does:

• Secures trim, panels, brackets or small components in place
• Stops loose parts that can cause rattling or vibration noises
• Restores correct fit where a missing or damaged screw allows gaps
• Works as a direct replacement when the original fastener is lost or stripped

• One screw

• Disconnect power and water before servicing the appliance
• Start the screw by hand to avoid cross-threading; use the correct driver bit
• Tighten snugly but avoid over-torquing to prevent stripping or part damage
• Keep removed hardware organized to ensure correct reassembly

This relay is an electromechanical switch that lets the appliance's control direct power to a load safely. Replacing a failed relay restores reliable on/off control and can resolve intermittent or non-working functions driven by the control.

• Receives a low-voltage signal from the control and opens/closes power to a component
• Typical signs of failure: the load won't energize, intermittent operation, repeated clicking/chatter, or visible heat damage/burning on the relay
• Can lead to symptoms like no operation of a heater, fan, or motor when the control calls for it
• Helps restore consistent switching to the affected circuit

• Disconnect power at the breaker or unplug the appliance before servicing
• Document wiring with a photo; move connectors one at a time and ensure tight, fully seated terminals
• Mount/seat the relay in the original orientation and secure any clips or screws

This cable harness is the factory-style wiring assembly that carries power and signals between your appliance's control and components, restoring reliable electrical connections and stable operation. What it does:

• Routes power and control signals between modules and components
• Replaces damaged, frayed, or connector-faulted wiring that can cause intermittent operation
• Helps stop symptoms like loss of power to circuits, unresponsive controls, or random shutdowns
• Maintains OEM-style connectors and wiring layout for proper fit and function

• Disconnect all power before servicing; follow lockout/tagout practices
• Compare new harness to the old one and route wires the same way to avoid pinching
• Reconnect all plugs fully until they click; do not force mismatched connectors

This electronic control module is the dishwasher's main circuit board that manages cycles, user commands, and system functions so the appliance runs the selected wash programs correctly. Replacing a faulty module restores control and cycle operation. What it does:

• Monitors and controls wash cycles, timing, and sequence of operations
• Receives input from the user interface and sends commands to valves, pumps, and heaters
• Helps regulate system functions like fill, drain, and wash/drain sequencing
• Common symptom linkage: unresponsive controls, dishwasher won't start or complete cycles, or intermittent/erratic behavior

• Disconnect power to the appliance before starting any work
• Handle the board carefully; avoid static discharge and impact to components
• Access typically requires removing the console or tub access panel—use appropriate tools

The Screw is an OEM part for Bosch microwave ovens. It is a component that secures the outer casing and front paneling of the microwave. The screw is designed to withstand repeated heating and cooling cycles without loosening or degrading. 

Symptoms of bad screw include:

- The front panel or outer casing becoming loose, detached, or misaligned
- Gaps appearing in the seams or joints of the microwave structure
- The door not sealing properly leading to leaks

Over many uses of the microwave, screws can wear down or strip out from over-tightening during repairs or installations. It is important to replace worn screws to ensure the microwave maintains an intact structure.

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.