Parts for Roper B4157X0: 05 - Full Glass Upper Oven And Lower Broiler Parts

A replacement hex nut used to secure appliance components and restore proper fastening. Installs quickly and helps stop loose or rattling parts caused by a missing or stripped nut. What it does

• Secures mounting studs, brackets, or components in place
• Prevents parts from shifting, vibrating, or coming loose during operation
• Replaces a missing, damaged, or corroded nut to restore reliable fastening

• One hex nut

• Disconnect power and gas before starting work
• Start threads by hand to avoid cross-threading, then tighten with the proper-size wrench
• Do not overtighten; snug until secure to avoid damaging studs or threads
• Use replacement only where the OEM hex nut is specified

This insulation retainer secures oven or appliance insulation to the cabinet, helping keep insulation in place for consistent heat control and quieter operation. It prevents loose insulation that can cause rattling or exposure. What it does:

• Holds insulation panels or blankets against the appliance cabinet or rear wall
• Helps maintain proper heat retention and consistent cooking or drying performance
• Reduces insulation shift and rattling noises during operation
• Prevents insulation from exposing internal components

• One insulation retainer

• Disconnect power (and gas if applicable) before servicing the appliance
• Allow the appliance to cool completely before accessing insulation
• Inspect surrounding insulation for damage and replace if deteriorated

This flat-head 10-32 zinc screw secures panels and components on compatible appliances, providing a corrosion-resistant fastener for reliable mechanical fastening. Use when replacing stripped or missing panel screws to restore proper fit. What it does:

• Fastens control panels, trim, or small appliance components with a 10-32 thread size
• Zinc plating helps resist rust and wear in typical household environments
• Replaces missing, damaged, or stripped flat-head screws that prevent panels from seating correctly
• Fits applications that require a countersunk/flush head for a clean finish

• Use the correct 10-32 driver bit and moderate torque to avoid stripping the head or threads
• Ensure the screw is the correct length and head style for your application before tightening
• Disconnect power to the appliance and follow OEM safety instructions before servicing