Parts for Frigidaire 2829A: Gas Range / Backguard Parts

This trim wrapper is the outer decorative trim piece that finishes the appliance opening and protects internal edges for a clean, finished look. It restores appearance and helps keep seals and components covered. What it does:

• Covers and protects the exposed edge of the appliance opening for a finished appearance
• Helps keep surrounding seals and components shielded from spills and debris
• Replaces cracked, bent, or cosmetically damaged trim that affects appearance
• Restores the proper fit and alignment of adjacent panels when the trim is the cause of gaps

• Trim - wrapper

• Disconnect power or unplug the appliance before starting any repair
• Remove adjacent panels or fasteners as needed; retain all screws and clips for reassembly
• Handle edges carefully—trim pieces and mounting points can be sharp
• Compare mounting tabs and screw locations to the original part before final installation

This right-side end cap is a replacement trim piece that secures and finishes the outer edge of the appliance door/frame, restoring appearance and helping keep the door components aligned for smooth operation. What it does:

• Covers and protects the outer edge of the door/frame and internal components from dirt and damage
• Holds adjacent trim and seals in proper position to reduce gaps and rubbing
• Restores factory appearance where a cracked or missing end cap left an exposed edge
• Helps prevent minor snagging when opening or closing the door

• Disconnect power to the appliance before starting any repair
• Removal/installation typically requires light prying or removing a few trim screws; use non-marring tools to avoid damage
• Align tabs or slots and press/secure the cap until it snaps into place; verify even fit along the edge
• If sealing or alignment issues persist after installation, check adjacent trim and fasteners for wear or damage

This part has been discontinued by the manufacturer and is no longer available.