Parts for Ge DDC4500SAM: 07 - Gas Valve & Burner Asm. Parts

Meters gas flow to the dryer burner. Replace if damaged, clogged, or when converting between natural gas and LP. Installs at the burner assembly.

This is a safety device installed in the gas supply line of a gas dryer that restricts gas flow in the event of a leak or line disconnection. It helps prevent dangerous gas accumulation by limiting the amount of gas that can escape. Replace the leak limiter if your dryer has difficulty igniting, produces a weak flame, or if a gas technician identifies it as faulty during a safety inspection.

Dryer won't heat or you smell gas? The gas valve controls fuel delivery to the burner. Common fix for heating failures and gas leaks. Moderate DIY repair.

Fix a dryer that won't heat or cycles but doesn't ignite with this gas burner assembly. Restores consistent flame when the original is corroded or clogged.

Fix a dryer that won't heat or ignite with this igniter. Common first failure on gas dryers. Most DIYers complete this repair in 15-30 minutes.

A dual coil gas valve controls the flow of gas to your appliance's burners using two electromagnetic coils to open and close the valve. It regulates gas delivery to maintain safe, consistent flame operation. Replace this part if your burner won't light, gas flow won't shut off, or you notice uneven flames or a gas smell during operation.

Hex washer head screw for refrigerators, freezers, and other appliances. Replaces lost, stripped, or damaged screws during repairs or panel assembly.

The gas valve solenoid controls gas flow to the dryer's burner assembly for heating during drying cycles. Located near the gas valve, replace it when the dryer won't heat, heats intermittently, or won't ignite properly.