Parts for Ge DPSE810GG6WT: 05 - Gas Valve & Burner Assembly Parts

Mounting screw for dryer drum support and internal components. Replaces lost, stripped, or damaged screws during repairs. Package of 12 screws included.

Meters gas flow to the dryer burner. Replace if damaged, clogged, or when converting between natural gas and LP. Installs at the burner assembly.

This is a safety device installed in the gas supply line of a gas dryer that restricts gas flow in the event of a leak or line disconnection. It helps prevent dangerous gas accumulation by limiting the amount of gas that can escape. Replace the leak limiter if your dryer has difficulty igniting, produces a weak flame, or if a gas technician identifies it as faulty during a safety inspection.

This assembly includes the gas valve and connecting pipe that control the flow of gas to the dryer's burner. It regulates when gas is delivered to the igniter and burner tube during the heating cycle. Replace this assembly if your gas dryer is not heating, heats intermittently, or if the gas valve fails to open properly during operation.

This small mounting screw secures panels and trim on compatible GE appliances, restoring a solid, vibration-free fit. Use it to replace a missing, stripped, or damaged fastener and keep parts aligned and secure. What it does:

• Fastens panels, trim, or small components to the appliance frame
• Replaces missing or damaged screws that cause loose or rattling parts
• Restores secure attachment when threads are stripped or worn
• Helps maintain proper alignment to prevent noise and component wear

• Use the correct screwdriver size to avoid stripping the head
• Tighten until snug; do not overtighten to prevent thread damage
• Disconnect power or move the appliance to a safe position when accessing internal panels
• Consider a replacement clip or insert as recommended by the manufacturer

Fix a dryer that won't heat or cycles but doesn't ignite with this gas burner assembly. Restores consistent flame when the original is corroded or clogged.

The Igniter is an OEM part for GE dryers. It is designed to ignite the gas burner to produce heat, which is essential for drying clothes. The igniter ensures that the gas is lit efficiently and safely, enabling the dryer to reach and maintain the proper temperature for effective drying.

You should replace the igniter if it becomes faulty. Causes of a bad igniter can include electrical failures, cracks or breaks in the igniter material, or wear and tear from regular use. These issues can prevent the igniter from generating the necessary heat to ignite the gas.

Symptoms of a bad igniter include:

• The dryer not heating up
• Extended drying times
• The igniter glowing but failing to light the gas burner
•  A lack of flame in gas dryers

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

A dual coil gas valve controls the flow of gas to your appliance's burners using two electromagnetic coils to open and close the valve. It regulates gas delivery to maintain safe, consistent flame operation. Replace this part if your burner won't light, gas flow won't shut off, or you notice uneven flames or a gas smell during operation.

Hex washer head screw for refrigerators, freezers, and other appliances. Replaces lost, stripped, or damaged screws during repairs or panel assembly.

The gas valve solenoid controls gas flow to the dryer's burner assembly for heating during drying cycles. Located near the gas valve, replace it when the dryer won't heat, heats intermittently, or won't ignite properly.

Converting your dryer from LP propane to natural gas? This conversion kit includes the orifice and components needed for a quick, straightforward swap.

Converting your dryer from natural gas to propane? This LP conversion kit includes orifices and instructions. DIY-friendly in under an hour.