Shaun G Boulder , MT September 04, 2015 Large heating element not working I wasn't sure if it was the heating element surface, the receptacle or the switch. My wife does some canning so it had some good use. It turned out to be the receptacle. I purchased the element as well thinking it needed replaced anyway. All works now. All three items are/would be easy to change. Read More... 20 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Alex B Silver Spring , MD January 15, 2017 Appliance: Model GE ELECTRIC RANGE Two burnt/damaged terminal blocks I lifted the front hood and removed the back control panel cover. I then replaced two terminal blocks with the new kits. Perfect match except wires were a bit long. So I rolled them up neatly and tucked them away at the control center. Used electrical tape to band both sets of wire and protect them from the metal edges between the range and control area. I replaced the control cover and installed two new burners. Perfect installation. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Carol J Raphine , VA November 04, 2020 Burners and drip pans were in bad shape, wanted to replace before moving in and cooking on the surface the first time I replaced all 4 burners and drip pans and they are a perfect fit. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers
Wade R Cedar Park , TX February 20, 2015 Appliance: General Electric Electric Range JBS07C3WW Had a cheap third party coil burner element and burner bowl and the legs of the burner did not align properly with the burner bowl causing unlevel cooking and unnecessary movement I ordered the correct General Electric replacement 8-inch coil burner element and the also the burner bowl and replaced each part of the affected burner. The replacement parts were of much higher quality than the cheap, imported junk burner and bowl. The design of the burner bowl is very different. Now the burner works as expected. It is level and solid without movement and the pots and pans sit firmly on the burner and are very stable. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
John L Sarasota , FL April 13, 2020 Appliance: Model JBP24W0B4WW The stove top 8" front burner shorted out with sparks going everywhere. I unplugged the stove and then looked for repair solutions. I ordered 2 new 8" elements along with the correct drip pans. I also ordered the replacement control switch and wiring plug/harness. Watched the Appliance Parts Pros repair videos and everything is working as designed. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Pliers, Screwdrivers