Michael M Keaau , HI September 20, 2014 Cycle timer broken loose from holding tabs inside backsplash Replaced backsplash and control knob Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Tiffany M Macclenny , FL October 10, 2015 Dial kept spinning Took the backsplash off and found that the clamps mounted to the backsplash that hold it in place were broken. I ordered a new backsplash from Appliance Parts Pro. Problem fixed. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Wrench Set
Christopher V Staten Island , NY October 17, 2017 Appliance: Model GTWN2800DOWW Backsplash has plastic parts on the back were broken and could not hold the the main selector switch anymore I replaced the the backsplash and put all the switches back into it. -- worked out great - no problem now--- you guys have a great site --thank you-- fast deliver like promised!!! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Joseph L St Peters , MO November 16, 2014 Appliance: Model GE WASHING MACHINE Splashboard was broken off/on switch/timer would not keep position Ordered the part, waited a couple of days and switched it out. Worked perfect. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Ronald R Tomball , TX July 05, 2019 Appliance: General Electric Washer GTWN2800D1WW The timer knob would keep spinning and not allow cycle selection After opening the washing machine panel, I inspected the timer and noticed a loose piece of plastic, which corresponded to the part of the panel (backsplash and) that the timer mounts to. I ordered the replacement part and it was delivered very quickly. There was no video, but it looked like they just snapped or twisted in. I removed the timer knob(there is a video for this) and the other three knobs. The switches twisted out after gently pulling on the metal retaining bar / clip. I just had to twist them back in and for the timer, I had to unscrew it to where no threads were through the other end. The alignment of the timer was a bit more difficult, as it took a couple tries to get it lined up right. I screwed in the retaining screw and reinstalled the knobs. I secured the panel and everything is back to working order. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Socket Set