Jiamin Z Allen , TX June 12, 2017 Appliance: Model GE AP3883205 / WB17X10021 Scb1001mss001 is dead nothing displayed Fuses are all OK, but the primary of low voltage transformer was disconnected. Replaced with new one, everything works good. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers
Albert F Montague , MI July 02, 2016 Appliance: General Electric Free Standing Microwave SCB1001KSS01 Mica canopy fell off and broke Replaced the canopy. Took a few trials to install. Once I realized than you slide the part towards the tabs til it stops and then while pushing up towards the roof pull it back under two metal ears it held it self in place. That was the easiest repair ever. Did not need any tools. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Carl B Walnut Creek , CA December 28, 2021 Magnetron was arcing. Unplugged and unscrewed Advantium Oven. Pull it out with the help of a friend as it is heavy. Removed the two screws on the top access cover and removed it. I removed the plug and discharged the capacitor just in case with an insulated wire to the ground. I needed a long #2 Philips screwdriver to access the 4 screws holding it in place. I swapped the thermostat from the old unit to the new unit. I used tape to hold the screws on the tip of the screwdriver to get them back in the holes. I swapped the old mica cover for a new one because the arcing splattered metal from the tip of the old magnetron and did not want any metal interfering with the microwaves coming out of the cavity. (The labor estimate for the mica cover was wrong) A couple of minutes at most. Plugin the magnetron and thermostat and button it up. Test it with a cup of water and good to go. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Ted Y Daytona Beach , FL October 22, 2021 The mica canopy burned up Reinforced the dog-ears with toothpicks glued across the tab/body and reinstalled after figuring out the indent cuts are designed to allow the fixed metal retaining tabs to pass and a slight slide to the right to engage them. Read More... Do-It-Yourself Rating: Repair Time Estimate: 2+ hours
Ted Y Daytona Beach , FL May 19, 2022 The shield that protects the generator deteriorated Bought exact replacement. It is a tricky install as the retaining tabs can be easily broken. Remove the old pieces Clean surfaces with warm water Carefully insert tabs into slots, constantly supporting the shield with light pressure Align shield to match existing detents on roof Gently slide shield to engage retaining lips on the interior roof. The first time I tried it I broke off a tab so take your time and examine the existing roof part. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes