Ge WD12X10401 Interlock Switch Cover OEM Part

Replaced door switches and plunger , spring. Other than the switches I believe the top of the plunger had contact issues as the updated part had larger contact

Installed 2 new switch interlocks. I actually had standing water in dishwasher and thought it was the pump. But I checked continuity, and it was fine. I thought it was the water inlet valve, and it too had continuity. I tested the OLD interlocking switches, and THEY WORKED. BUT only when the side button was completely pressed down. (The plunger wasn't wide enough to completely press down the switch). The NEW switches (closed the circuit) when only PARTIALLY depressed. This allowed the dishwasher to complete the sensing mode and start the other process. While I had the door apart, I also replaced plunger, spring, cover and door latch. Through trial and lots of ERROR :), the entire process was about 3 weeks. Actually FIXING the problem, less than 15 minutes :)

Just by replacing it. I have also replaced the Interlock Switch Plunger to be sure.

Had the same problem before. Talked with tech on phone we figured out what parts were needed.

We replaced the interior door plunger, spring, and cover. The video from AppliancePartsPros.com was very helpful and made the job very easy to complete.