Mark H Glendale , AZ February 29, 2016 Ice jamming fill cup coming off Replaced the stripper and fill cup - turns out that the fill cup came with the locking tab broken off. The stripper had a missing paddle, and ice cubes would jam and shut down the ice maker periodically. Let the ice maker warm up after you remove it so the plastic is not so brittle. You have to pry the old stripper out. Make sure the new one locks all across the front. My refrigerator has the ice maker mount toe the side instead of from the hangers in back. I wasn't sure how to remove it, but it turns out not to be a problem. Just take the one screw towards the front side all the way out, and then the ice maker slides out from the two knobs holding it in the back side. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
David S Carriere , MS June 05, 2016 Water was going down back of freezer instead of going into ice maker When I bought the freezer it was putting too much water in ice maker. The cubes were too big and they were constantly pushing on the cup that was to divert water int the tray. It finally broke the tab that held it in place. I have looked off and on for four years for a new one but nobody could help. I finally was on your website and scrolling through parts and found it. So I bought 2 since they were so inexpensive Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Joseph R Wall Twp , NJ April 02, 2016 Icemaker All went great u have great service &shipping thank you. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers
John K Waco , TX November 23, 2020 Appliance: General Electric Refrigerator HSS25GFPDWW Water all over the ice bucket, freezing the cubes together. I had replaced my icemaker with one that came with generic parts, like a different fill cup. I'd had trouble finding the correct fill cup until finding one on this site. Since I had dealt with unwanted icing in this area previously I was able to simply pop the old fill cup out and put the new one in. I was also able to remove a filler tube "extension" that had come with the replacement icemaker, simplifying the installation. I didn't need to remove my icemaker to replace it. I think if you were replacing one that was original you might need a screwdriver or pliers to remove the old one, and might need to remove the icemaker. The new one was damaged, so I contacted them and I received a new one the next day. Couldn't be happier! Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Jeffrey W Daufuskie Island , SC June 24, 2019 The fill cup was out of position and water spilled out and formed a block of ice Defrosted the refrigerator so I could remove icemaker. Ordered new fill cup and installed it when I received it, reinstall icemaker, and happily make cold drinks. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers