Cindy R Alto , TX March 03, 2016 Broken door gasket It was fast and simple. Pulled off the old one and snapped the new one in place. Took only a couple of minutes. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Jack B Mission Viejo , CA July 03, 2015 Dryer was making an unusual noise like something rubbing or a bearing going bad Quick check revealed the idler pulley had worn the side completely down and the belt was rubbing on the shaft. Ordered the new idler pulley from Appliance Parts Pros. It arrived in a couple days. Replaced the part and in about 10 minutes had the dryer up and running again. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Thomas H Whittier , CA January 02, 2016 Squeeking noise I took it apart to the point that I could see a very worn out drum glides and assembly then I lubed the idler pulley. Ordered new parts to replace worn, installed them and now good to go.. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Ronald P Port Charlotte , FL June 05, 2016 Appliance: Model DBXR463EBOWW Replace dryer door gasket Replaced it with help from your agent when I called Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Doug C Vacaville , CA December 14, 2014 Appliance: Model GE DRYER DBXR453GT5WW Parts worn with age needed a tune up Took it all apart, cleaned every nook and cranny, and replaced all the gaskets, bearings, belt and its pulley. Read More... Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set