Ge WD24X10014 Dishwasher Drain Hose OEM Part

I replaced the pump drain assembly. The flapper valve was included in the assembly, so I did not need to order that. On previous repairs, the old drain hose was tricky to reinstall, so I replaced it and the hose clamp.The silverware basket had holes in the bottom and required replacement. I had some broken tine clips.

I replace drain hose and this took care of problem.

Ordered new lines took about 2 minutes to replace, using only needle nose pliers to depress the compression clamps

Original installer used a regular rubber drain hose. When hot water heated up the hose it collapsed because 1) It was not the correct hose. & 2) It was forced through a small opening in the cabinet wall along with the copper supply line. Two sources of heat combined with the small opening in the cabinet wall caused the no drain situation. I replaced the hose with the corrugated hard plastic hose that comes with the dishwasher, problem solved. I don't know why the original installer did not use the correct hose. He said it was too short, but I had no problem at all.

I found the parts through the G.E. parts manual and ordered them through Appliance Parts Pros. Replacement of parts was pretty easy with a couple of youtube videos. Parts were delivered promptly and well packaged. All in all about an hour of total time to get the tools together, pull the dishwasher from under the cabinet, and replace the parts. Also cleaned out filter assembly while I had the parts out.