Franklin A Berkeley , CA April 17, 2015 Appliance: Model JBP35DMWW Faceplate graphics on 3 year old ge range in rental unit was damaged from heat cracked and discolored Ordered a new Faceplate Graphics, removed old faceplate and installed new. Required removing control panel with switches and display, including 10 screws to get to the faceplate. Faceplate has glue on rim, so had to peel off old faceplate, remove residue, then put on new. Not difficult, but reaching to remove the screws was a little challenging in a small kitchen. Now unit looks brand new! Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
James S San Diego , CA October 14, 2025 Control board module had wear and tear issues replaced it Watched your videos; ordered the part from you; also had ordered the sticker. The video had not reference that once the new control board was installed you would have to program it for the stove that I had. The instructions came with the new part, all the same it would have been a good heads up before I received the new part. I had to do a little digging online to find the cross referenced part number. All in all I always have appreciated APP. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Pliers
Robert H Garner , NC March 13, 2021 Appliance: General Electric Electric Range JB700DN1WW My oven control unit's temp/timer/clock up arrow was erratic. It would not easily increase temp timer or clock when trying to change the setting. Purchased a replacement oven control unit and also the Faceplate stick on graphics. Found different YouTube videos showing how to change the control unit on my GE oven/burner range. Based on what I learned I was able to replace the control unit. I put the new Faceplate graphics on the control unit first, then swapped out the control unit. Removing a couple of the connected wires was a challenge, but got them all off. Went onto the new control unit easily. One observation about purchasing a new Faceplate graphics. I didn't trust being able to remove the old stick on graphic, so purchased a brand new one. Good move. The oven is at least 10 years old, and the Faceplate Graphics did not come off the old unit without tearing and not being reusable. So, don't try to save money, buy a brand new Faceplate Graphics stick on. Also, there are 4 raised edges on the control unit that help you align the Graphics. I did not see them until after placing the Graphics on the unit the first time. Then felt the raised edges of the guides. Was able to pull the Graphics off and realign to the 4 raised edges (two on bottom, two on right side). Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers, Socket Set