Purchased a replacement oven control unit and also the Faceplate stick on graphics. Found different YouTube videos showing how to change the control unit on my GE oven/burner range. Based on what I learned I was able to replace the control unit. I put the new Faceplate graphics on the control unit first, then swapped out the control unit. Removing a couple of the connected wires was a challenge, but got them all off. Went onto the new control unit easily. One observation about purchasing a new Faceplate graphics. I didn't trust being able to remove the old stick on graphic, so purchased a brand new one. Good move. The oven is at least 10 years old, and the Faceplate Graphics did not come off the old unit without tearing and not being reusable. So, don't try to save money, buy a brand new Faceplate Graphics stick on. Also, there are 4 raised edges on the control unit that help you align the Graphics. I did not see them until after placing the Graphics on the unit the first time. Then felt the raised edges of the guides. Was able to pull the Graphics off and realign to the 4 raised edges (two on bottom, two on right side).