Ira W Grantsville , UT April 01, 2020 Cooling fan burned up. I had to take the top panels off and two back panels off. Took off about thirty screws. It was very dirty and dusty inside so I took the lower panels off as well to clean and vacuum it. The hardest part was getting the double oven out of the cabinet. Overall it was very doable. Read More... 17 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
George P Driftwood , TX June 25, 2021 Appliance: Model JT5500SP3SS Error code F96 on GE oven jt5500sp3ss To replace the cooling fan which is located on the upper back left of the oven, it required removing the oven and 3 metal panels. To remove the oven the best way was to remove the oven doors first which will reduce the weight significantly. Once I did this it was much easier to left the oven by myself and move on a self made stand. After the removal of the metal panels there were 4 screws to remove the metal plate holding the fan to oven, 2 electrical plugs, and then another 4 screws to remove the fan from the metal plate. After a little cleaning to remove some grease and replacing the fan (also replaced the Hall Effect module but I don't think this was bad), it was easy to put back into the oven reversing the process. Also please remember to remove power during this process. Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Jack L Lamoille , NV November 24, 2020 Error code came on indicated fan blower system failure only 2 parts were in that circuit (1) fan sensor (2) fan blower ordered both and changed them out it appears to be working. Removed oven from cabinet, removed fan assembly and re installed. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Nut Drivers, Screwdrivers
Bernard M Summerville , SC May 09, 2020 Appliance: General Electric Electric Wall Oven PT7550SF4SS Error code f96 Upper oven cooling fan was not working for my GE Profile double oven. Turned off power to oven at breaker. Took photo of wiring in the box above the oven and unattached wires from wall. Removed the doors by opening all the way and removing black metal brackets with single Philips head screw, released the locks downward, pull the door upwards about 45 degrees and pull out. Used Phillips screwdriver and remove 4 screws holding oven to the cabinets. Two people need to pull the oven out, it is really heavy, place on cardboard, slides around easy now. Remove top panel, all 1/4 hex screws and top back. Cooler fan is directly top back of oven. More hex screws and detach electrical connectors. Placed new fan and put back to get her in reverse. It took 1.5 hours. No more error code, oven works Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers, Socket Set
Christian F Westminster , MD November 10, 2021 F96 blower not working Replaced blower and onboard sensor. Cleaned a lot of grease from inside housing Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers