Ge WR02X11666 Frame, Lower Pan OEM Part

This is the SECOND time I have replaced this part. The first time was due to the plastic draw rails cracking and the draws would not go in and out correctly. This time (the second time) the frame actually cracked in the left rear corner. This is not a real simple part to replace, as getting the 'old' parts out can be tricky. Just let the old frame warm up to room temp before you begin. Have some nice flat blade screwdrivers and rigid putty knives - as you will need these. Getting the center draw guide out is the most tricky. Do the back first, using a flat rigid putty knife to carefully lift the tabs that hold that part in on BOTH top and bottom. You will find having an extra set of hands will help.

Put in new tray

After reading previous reports about how to replace this piece I was skeptical whether I could fix it without breaking a piece. I was very careful and it took longer than expected (30-60 minutes). There definitely needs to be some instructions or video to help the customer. I did wait for the old frame to warm so it wasn't so rigid and needed just screwdrivers and lots of patience! Removing some of the old pieces like rubber seal and humidity controls was relatively easy if you just look to see how they were placed in old frame. I rated my experience four star because I accomplished what I set out to do!

With the parts requested.

Replaced it with a new one purchased from Appliance Parts Pro.