General Electric Garbage Disposal Parts

Retaining ring secures internal components in your garbage disposer. Replace if loose, damaged, or during motor repairs. Verify fit with your model number.

This replacement wire tension spring restores proper tension and movement in the appliance's mechanical assembly, helping components return to their correct position and operate smoothly. What it does:

• Provides tension and controlled return for a moving linkage or door/lid assembly
• Helps reduce binding, sagging, or misalignment caused by a worn or broken spring
• Restores smooth mechanical operation where a spring is used to counterbalance or tension a part
• Common symptom: noisy operation, loose or non-returning linkages where a spring is required

• One replacement wire tension spring

• High-level replacement only; verify exact spring orientation and attachment points before removing the old spring
• Use proper hand protection and eye protection; springs can release suddenly under tension
• Disconnect power and follow appliance-specific safety procedures when needed

Sink flange gasket seals your disposer to prevent leaks. Replace if you notice water dripping from the connection. Confirm fit with your model number.

This grinding ring is the wear surface for the appliance's grinding assembly, replacing a worn or damaged ring to restore normal grind performance and reduce noise from metal-on-metal contact. What it does

• Serves as the replaceable wear surface inside the grinding chamber
• Helps maintain proper clearance between grinding components
• Commonly replaced when you hear excessive grinding noise or reduced grinding efficiency
• Can prevent further damage to mating grinding parts by restoring proper contact surfaces

• One grinding ring

• Disconnect power to the appliance before starting any disassembly
• Removal requires partial disassembly of the grinding chamber; follow the OEM service manual
• Use gloves and eye protection to avoid sharp edges and debris

Secure your disposer shroud with this support ring clip. Replace if shroud is loose, rattling, or not seating properly. Verify fit with your model number.