General Electric Ice Machine Parts

The Electromechanical Icemaker Kit is an OEM replacement part for GE refrigerators. It includes the ice maker assembly components responsible for harvesting, ejecting, and monitoring the ice-making process.

Symptoms of a faulty electromechanical kit include: 

• Ice not being produced or dispensing properly
• The ice maker failing to turn on or stop automatically
• Strange noises emanating from the ice maker

Causes can be worn parts like the ejector assembly or drive motor, as well as electrical malfunctions. Continued use puts wear on components that regulate ice production.

This OEM GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models. Replace yours today for reliable ice on demand.

This refrigerator water line is the plastic tubing that routes pressurized water through the appliance's water system. Replacing a cracked, brittle, or kinked line helps restore proper water flow and prevents leaks inside or around the unit.

• Carries water between the inlet valve and the refrigerator's water system components
• Helps maintain a sealed path for reliable flow to the dispenser and/or ice maker
• Replace if tubing is cracked, kinked, brittle, or leaking
• Common symptoms include puddling, dripping, reduced/No water at the dispenser, or ice maker not filling

• Disconnect power and shut off the water supply before servicing
• Note the original routing and clip locations; avoid sharp bends and kinks during installation
• Fully seat tubing into existing connectors/fittings on your model
• Turn water back on, check all connections for leaks, and purge air by dispensing water

This genuine replacement part is a water valve for refrigerator ice makers. The water valve supplies water to the ice maker to fill the water reservoir. If the icemaker is no longer operating properly and no longer dispensing ice, it might mean that the water valve needs to be replaced. Thankfully, replacing this part is an easy repair. To begin, make sure all the power is turned off to the appliance. Open the freezer door where the water dispenser is located. Remove the inner panel of the door by unfastening the screws that secure it. Once the panel has been removed locate the old water valve and release it from its mounting brackets. Once removed, replace with the new water valve. Reinstall the door panel and restore power to the refrigerator. This OEM part is compatible with General Electric, Hotpoint, and RCA brand refrigerators.

This thermistor senses the temperature inside the refrigerator bin/drawer and provides the control board with the signal it needs to regulate cooling. Replacing a bad thermistor restores accurate temperature readings and more consistent cooling. What it does:

• Measures bin/drawer temperature and sends a voltage/ohm signal to the control board.
• Helps the refrigerator maintain set temperatures by enabling proper compressor/fan control.
• Common symptoms of a failing thermistor: incorrect bin temps, inconsistent cooling, or temperature-related error codes.
• Use when diagnostics point to a faulty temperature sensor or when the thermistor is damaged.

• Always disconnect power to the appliance before starting any repair.
• Handle the sensor and wiring gently; avoid contaminating or bending the sensing tip.
• Reconnect using the original connector and route the harness the same way to prevent pinching.

This water pump is the replacement pump assembly that removes standing water and helps the appliance drain properly. It restores normal draining and prevents water from pooling after a cycle. What it does:

• Pumps water out of the tub or sump so the appliance can drain
• Commonly replaces damaged or noisy pumps that run but fail to move water
• Can resolve symptoms like water remaining after a cycle, slow draining, or unusual pump noise
• Works as the fluid-moving component in the appliance's drain/circulation system

• Disconnect power (and water supply if applicable) before starting any repair.
• Handle the pump and impeller carefully; avoid contaminating seals or electrical connectors.
• Inspect hoses and clamps for wear and replace if needed to ensure a proper seal.