Radoslaw Z Davenport , FL April 02, 2016 Dishwasher won't start I've ordered new main and tactile board and installed it. Everything worked fine after boards exchange. Ran full cycle, no problems at all. Dis-assembly and installation was really easy, all I needed was Phillips screwdriver and a star tip attachment wrench (I'm always asking myself question why this is done like that? , why can't it be just regular Phillips screw?) Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Robert P Pennington , NJ November 29, 2014 Appliance: General Electric Dishwasher GLD4408R00WW Control panel buttons would not work stayed lit but did nothing on ge profile dishwasher only four years old Replaced control panel and board. Follow the enclosed instructions. Dont forget to take the jumper off of old board and put on new board. the instructions are very clear. youll need a torx head too for one of the panels to be removed. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Charlie G Cocoa Beach , FL May 12, 2015 Control board failed after voltage spike Replaced both electronic boards. Requires a Torx T-15 driver and Philips head screwdriver. Easy to fix. I ordered the part at 4pm and had the part the next morning a 9 am. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Jonathan R Norwood , MA December 26, 2014 Control board failure Replaced the control board Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Raymond L Winchester , IL July 06, 2021 The start pad hard to turn on. Replaced the board kit. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers