Ge WB26X10208 Microwave Turntable Motor OEM Part

I replaced the motor by removing 5 screws from the bottom of the microwave and 1 screws from the motor. Very easy to replace, I didn't even have to remove it from the wall (I unplugged it just in case).

Bought both replacement parts. Unplugged power. 5 screws will unhinge the bottom hanging panel of the MW. Be careful of the lighting unit also a part of the panel. Motor is removed with one set screw after you unplug its power source. I inspected the Coupler and it was also damaged (stem cracked). I replaced the Coupler first (make sure fitted to proper height for Turning Plate inside MW) then fitted the new motor to the Coupler stem, put new motor back into its holder, returned set screw, and hooked power source back up. Tested the repair. Might as well pull off the bottom panel and clean it all up since you have gone that far. Less than 10 minutes excluding scrubbing down the panel.

Took the motor out to find the part number, searched online, found appliance parts pros via Google - ensured I had the compatible part, order it, installed it, done! boom. super easy thanks!!

It took about 15 minutes to install a new motor. Works fine.

Ordered parts on line, received parts, unplugged microwave. Removed bottom panel to gain access to turn table motor, removed screw holding motor in place, unplugged electrical contacts and replaced motor and coupler. Replaced bottom panel and replugged microwave. Works fine. Very satisfied.