Kwong L Savage , MN October 17, 2016 F7e6 Change the controller Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Linley J Afton , OK March 30, 2016 Appliance: Model GE MODEL # JTP 20 Control module failed and all oven functions were disabled I simply replaced the old module with the "exact" replacement part. The entire experience was made easy by a superb website with pictures, proper model and part numbers, and an easy ordering process. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Stevie G Fort Gibson , OK July 06, 2020 Wasn’t heating and maintaining temperature. Ordered the oven control and put it on. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers
Marivic B Alta Loma , CA October 03, 2016 Appliance: Model JTP25S0H6SS The oven was giving intermittent error code f7 e6 Replaced the oven control(ERC3B) and so far so good it's been working (knock on wood). I found your web site through the internet and through a YouTuber's recommendation. My husband was the one that disassembled the Control panel. The only difficulty was disconnecting the wire cables. It was hard detaching them without breaking them off. Thank you so much! Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Robert H Palo Alto , CA April 03, 2023 Appliance: General Electric Electric Range JTP20SF1SS After a power surge (i was told the neutral had been energized) the display was completely blank but the oven light still worked I had a repair person looking at the furnace, which also got fried. Since he was able to fix that so quickly, he offered to look at the oven for free. He verified that there was still 2-phase power to the oven and said that the only thing that could really be causing the problem was the control That confirmed my somewhat less informed analysis and I was therefore more confident in ordering the part. He also walked through what would need to be done for the exchange. It was good that he showed me how to "unlock" the ribbon cable so that it could be removed. When I got the part, the replacement was pretty fast and went without a hitch. The hardest part was removing the single-wire clips on the old controller, but the gentle use of pliers helped there. Also, the new part had a minor difference from the old part, but it was clear where the wires needed to be hooked back up anyway. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers, Screwdrivers