Ge WB07X10034 Range Door Handle Endcap OEM Part

Removed old handle endcap by unscrewing the two outer screws on the oven door that screw into the endcaps and holds the door together that allows you access the one inner screw that holds the endcap in place. I removed the broken endcsp and replaced with the new one and screwed everything back together.

Had to unscrew the bolt on inside of oven door with a T15 torx bit. The inside and outside half of the door will come apart when the bolt is loosened from the endcap. Don't pull these two halves apart. There is a metal spacer on the long bolt you can just leave in place. On the inside of the outer 1/2 of the door, there are two smaller screws holding the endcap on (unless they've broken loose) that you need to take off with a 1/4 socket or wrench. You have to take these off, then the endcap comes off. Put the new endcap where the old one was, connect the two screws and the long bolt in the holes and you're done! I lost one of my inside screws, so I replaced it with a small wood screw. HOPE THIS HELPS! :)

A Torx T15 screw holds the handle on. Watch out for a plastic spacer between the inner and outer door.

As a single senior female, I got quite a surprise when I went to open the oven door and it came off in my hand. I completed my cooking with some difficulty with the door and then went to my computer to find the manufacturers replacement part, It would have been cheaper to buy a new stove for this part so I scoured the internet to see if I could just order the broken endcap that had caused the break and went on the ApplicanceParts Pros.com and found exactly what I needed, I ordered the part on line and requested standard delivery. That was early on Friday morning, to my surprise the Fedex truck arrived early Saturday morning with the part. Wow! such efficiency. I was really impressed. I've got my oven door back working and once again, I'm baking

I located the screws on the inside panel of the oven. I discovered there were two small screws attached to the handles that had to be taken off first. Once the ends were off I simply attached the handle and attached the ends in reverse order.