Ken B Brandon , FL March 09, 2016 I had 3 side rails that were broken The new slides fit perfectly. One thing to mention is that the slide rails come with the slide bearings so you do not need to buy those separate. When I called I was told I needed the bearings so I bought 3 assuming I would be able to salvage the others. Turns out I did not need them. Read More... 36 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
David L Union Gap , WA October 18, 2016 Was getting water to ice but not to the water dispenser Changed out the valve and cleaned the lines out Read More... 32 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Anthony L Boxford , MA October 16, 2016 Appliance: KitchenAid Undercounter Dishwasher KUDI01ILBT2 Poor washing results of glasses in the top rack I replaced the spray arm seal and center manifold. The old seal looked slightly worn and the old manifold mating/spinning surface was thinned out. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
David D Constantia , NY November 30, 2014 Appliance: General Electric Refrigerator GSS25JSRESS I bought a used fridge with some damaged and broken drawer rails The fix was about as simple as could be. Remove two screws from each broken rail, clean walls behind rails and then replace by reinstalling the screws in the new rails. My oniy regret was not ordering all 4 rails because I discovered the fourth rail is also damaged. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Kerwin S Loveland , CO October 30, 2019 Appliance: General Electric Refrigerator GSS25JERFBB Three out of the four side assemblies on the lower drawers were broken and no longer useable I replaced the side assemblies with new ones. One bad assumption I made from looking at the diagrams was that I would also need the small, plastic, slide bearing clips, so I ordered a couple. The new assemblies come with three of them already installed. Also, each assembly is attached with two short Phillips-head screws, so that's an easy fix. Just note the placement of the original piece, or take a photo, to help with the new installation. I took a little more time to clean everything up while the parts were out of the frig. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers