Parts for Craftsman 316.29270: General Assembly Parts

This replacement part is a throttle cable. This is a genuine replacement part made by MTD. This part is responsible for assisting the user in starting and stopping the appliance according to the desired settings. A new throttle cable might be needed if the current set of wires are stripped down or worn in any way. This can be from years of normal wear and tear or from a single incident that may have caused damage. If this is the case, it is recommended that this part be replaced as soon as possible. If the cable is unable to stay attached to the necessary parts, it should be replaced. This is a genuine OEM replacement part. This part is sold individually and is sourced directly from the manufacturer.

Support bracket assembly for tiller frames. Secures and stabilizes internal components. Replace if bent, cracked, or damaged from impact or wear.

If your tiller won't engage or makes grinding noises, the gearbox assembly may need replacement. This component transfers power to the tines for soil tilling.

Right-hand inner tine for tillers. Installs on the tine assembly to cultivate soil. Replace if bent, broken, worn down, or missing for proper tilling.

This replacement part is a pin lynch. This is a genuine replacement part made by MTD. This part is small but important to ensure that the axle or shaft is working properly during use.A new pin lynch might be needed if the current one is missing or damaged. It is not uncommon for the pin to be stripped down over time due to normal wear and tear in the machine. Often times the pin also gets lodged into place and should be replaced if this ever occurs. Wear work gloves when completing this repair to prevent injury. The engine should be completely turned off and cooled down. This part is sold individually and is sourced directly from the manufacturer. This is a genuine OEM replacement part.

Replacement tine for edgers and tillers. Installs on the rotating shaft to cut through soil and edges. Replace when bent, broken, or worn down from use.

Replace your tiller's cracked or broken plastic wheel. This 5-inch wheel installs on the axle to restore mobility and maneuverability during operation.

Tiller won't engage or makes grinding noises? This drive shaft housing assembly protects the drive shaft and connects the tiller head to the engine.