Parts for Trimmer Plus 41AJLD-C954: General Assembly Parts

Replace a worn or broken flex drive shaft causing your line trimmer to stop spinning the cutting head. Direct fit for multiple gas trimmer models.

The gearbox assembly is found in tillers and is where the gears are housed that supply the drive and torque for the unit. The gearbox assembly is designed to provide protection for the gears and the other internal components, which are responsible for transferring energy to increase torque and control speed. Although it is made of durable materials, it may become worn or damaged over time and require a replacement. This genuine OEM gearbox assembly is produced to exact manufacturer standards and made to be used in compatible machines from Yard-Man, Ryobi, Yard Machines, Bolens, Cub Cadet, and MTD. The gearbox assembly is sold as an individual assembly and comes ready to install with the four screws required for installation. Be sure to wear gloves and disconnect the power from the tiller before performing any repairs. Allow the unit to cool completely and follow the diagram to ensure that the replacement part fits exactly. This assembly will require a screwdriver and wrench set to replace.

This replacement part is a pin lynch. This is a genuine replacement part made by MTD. This part is small but important to ensure that the axle or shaft is working properly during use.A new pin lynch might be needed if the current one is missing or damaged. It is not uncommon for the pin to be stripped down over time due to normal wear and tear in the machine. Often times the pin also gets lodged into place and should be replaced if this ever occurs. Wear work gloves when completing this repair to prevent injury. The engine should be completely turned off and cooled down. This part is sold individually and is sourced directly from the manufacturer. This is a genuine OEM replacement part.

This is an accessory hanger that is intended for use with a variety of lawn and garden equipment. It attaches to equipment so the tool can be hung up for storage. The hanger can help to ensure that tools are easy to access in an out of the way space.The hanger that is currently on the machine could be damaged or could crack after a lot of use, and it might need to be replaced. It is an easy replacement and should only take a matter of minutes at most.This hanger can be used with trimmers, edgers, pruners, blowers, and cultivators from Ryobi, Troy-Bilt, MTD, and Cub Cadet. Each hanger is sold individually. Owners with multiple pieces of equipment will want to buy as many as needed. This is a genuine OEM part sourced from the manufacturer.