Gibson Range / Cooktop / Oven Screws, Nuts, Washers

Black hinge washer for electric and gas ranges. Replaces worn, cracked, or missing washers on door hinges to ensure proper door alignment and support.

This hex nut secures mating bolts and studs to hold appliance components in place, helping maintain stable connections and safe operation. It's a simple, replaceable fastener used where threaded hardware is required. What it does:

• Secures a bolt or stud to prevent parts from loosening during operation
• Provides a reliable threaded connection for panels, brackets, or assemblies
• Restores proper fit when an original nut is stripped, corroded or missing
• Helps reduce vibration-related movement when used with the correct mating hardware

• One hex nut

• Verify matching thread size, pitch and nut style to the original before installing
• Hand-start the nut to avoid cross-threading, then tighten
• Replace any damaged or corroded mating hardware to ensure a secure connection
• Disconnect power and follow basic safety procedures before servicing the appliance

A truss-head shoulder screw used where a short, smooth bearing surface and a wide head are needed for pivoting or locating parts. Replaces worn or missing screws to restore proper alignment and movement. What it does:

• Provides a smooth, stepped shaft (shoulder) for parts to pivot or slide on
• Secures components while maintaining precise spacing and alignment
• Stops looseness that can cause rattling, binding, or uneven movement
• Works in assemblies where a wide truss head prevents pull-through

• Use the correct screwdriver or bit to avoid stripping the truss head
• Do not overtighten; torque just enough to secure the part while allowing intended movement
• If working near electrical components, disconnect power to the appliance first

Secures internal components and panels on your electric range. Replace if missing, broken, or loose to restore proper assembly and structural integrity.