Gibson Washer Switch

This pressure switch senses pressure changes and signals the appliance control to start or stop functions, helping restore proper operation when pressure-based controls fail. It's a direct-replacement style switch used in compatible Frigidaire appliances. What it does:

• Detects and closes or opens an electrical circuit based on air or water pressure changes
• Signals the control board to advance cycles or enable components (pump, valve, blower)
• Common symptom indicator: appliance won't complete cycles or responds inconsistently when pressure-controlled
• Helps stop operation when pressure limits are reached to protect system components

• One pressure switch

• Disconnect power (and water, if applicable) before starting work
• Handle the switch and its terminals with care; avoid bending pins or cracking the housing
• Inspect and replace any associated tubing or fittings that are cracked or clogged

This pressure switch is a replaceable pressure-sensing control that tells the appliance when system pressure has reached a set level so the unit can advance through cycles correctly. Installing a working switch restores reliable pressure-based control. What it does:

• Senses system air/water pressure and sends a signal to the control board
• Helps the appliance detect fill, drain or airflow conditions used to advance cycles
• Common symptom: appliance shows pressure or fill-related errors or fails to progress through cycles
• Can correct intermittent or no-response behavior when the original switch is faulty

• One pressure switch

• Disconnect power (and water if applicable) before servicing
• Remove and replace only with the exact matching part number
• Handle vacuum/pressure tubing carefully; ensure airtight connections
• Verify operation with a multimeter or by following OEM test procedures

This rocker switch replaces a worn or broken on/off control for the appliance, restoring reliable manual control of the affected function. It's the direct-fit switch used where a small rectangular rocker actuator is needed. What it does

• Acts as the user-operated on/off control for the circuit it serves.
• Restores power control when the original switch no longer clicks or stays in position.
• Common symptom: switch feels loose, is stuck, or the circuit does not respond when the switch is operated.
• Uses the same mounting and electrical connections as the original to simplify replacement.

• Disconnect power to the appliance before attempting service to avoid shock.
• Access usually requires removing a control panel or console; keep track of fasteners and wire locations.
• Transfer wires exactly as removed; confirm firm terminal connections.
• Test switch operation and restore power only after reassembly.