Parts for Caloric STD6502D/P1119908S: Glass Top And Control Components Parts

This infinite switch controls heat levels for one cooktop burner, restoring precise temperature regulation for electric ranges. Replaces a worn or faulty burner control to help burners cycle and hold set heat. What it does:

• Regulates power to a single surface burner so you can set low to high heat levels
• Commonly used when a burner won't heat, has no low/high change, or heats inconsistently
• Steps the element through variable heat settings instead of a simple on/off
• Works with standard rotary knob controls

• Disconnect power at the breaker before accessing the range surface or control area
• Handle internal wiring carefully; match wire colors/positions during reinstallation
• If mounting screws, terminals, or insulation are damaged, replace them before use

This blower seal sits between blower housing components to prevent air leaks, helping direct all exhaust air through the drum and vent. Replacing a worn seal can help restore proper airflow and drying performance. What it does:

• Forms an airtight gasket between the blower housing and its cover/duct
• Helps maintain correct airflow and temperature balance through the drum and exhaust
• Reduces lint and dust escaping into the cabinet
• Common failure symptoms: longer dry times, weak vent airflow, whistling or rattling from air leaks

• 1 blower seal

• Disconnect power and, for gas dryers, shut off gas before servicing
• Access the blower housing; remove the old seal and clean mating surfaces of lint and residue
• Position the new seal flat and even; reassemble without pinching or deforming the gasket
• After reassembly, verify strong exhaust airflow and check for leaks

This is a one inch piece of tape