Parts for Ge ZGU486NDT2SS: Griddle Assembly Parts

Grease trough assembly collects spills and debris on your gas cooktop. Replace when cracked, warped, or rusted to maintain proper drainage and cleanliness.

Mounting bracket for cooktop griddle plates. Secures griddle accessory to cooktop surface. Replace if bent, broken, or missing to properly install griddle.

Mounting screw hardware for ranges and cooktops. Replace missing, stripped, or corroded screws used to secure panels, brackets, or components.

This burner griddle provides a flat cooking surface designed to sit on your range burners for even griddle-style cooking — great for pancakes, sandwiches and foods that need a wide, stable surface. What it does:

• Replaces a worn, warped or missing range griddle so you can cook evenly across burners
• Creates a single large cooking area for flipping foods and using multiple burners at once
• Helps prevent food from falling into burner areas and makes pan-to-griddle transfers easier
• Restores proper contact with burners to improve heat distribution when the griddle is damaged

• One burner griddle

• Allow the range and burners to cool completely before removing or installing the griddle
• Position the griddle carefully over the burner openings so it sits flat and stable
• No special tools required for basic placement; follow all safety instructions in your owner's manual; disconnect power or gas supply if performing any service that requires it

Replaces a damaged, cracked, or worn griddle top cover on your gas cooktop. Restores proper fit and appearance while helping contain heat and spills.

This pad cover is a replacement protective trim that restores the appearance and protection of a damaged or worn control panel area. It helps prevent dirt and moisture from reaching switches and pads while keeping the unit looking finished. What it does:

• Covers and protects the control-pad or switch area from spills, grease, and debris
• Restores a clean, finished look to a worn or damaged panel
• Helps reduce the chance of contamination affecting underlying switches or contacts
• Commonly replaced when the panel shows visible wear, cracks, or peeling

• One pad cover as shown

• High-level replacement — remove the old cover and snap or fasten the new cover into place
• Handle carefully to avoid scratching the finish during installation
• Disconnect power or follow appliance-specific safety steps before working near electrical components
• Use only approved replacement parts for your model

This pad cover is the replacement outer cover for a range or appliance control panel, restoring a clean appearance and protecting the underlying control pad from spills, dirt and wear. It helps keep buttons accessible and the panel looking new. What it does:

• Protects the membrane/control pad from moisture, grease and debris that can cause sticking or wear
• Restores a cracked, faded or damaged control panel surface for improved appearance and usability
• Helps prevent dirt from reaching electronic controls and buttons
• Can reduce accidental presses by providing a smooth, intact surface

• Disconnect power to the appliance before attempting repairs to avoid shock or damage
• Remove trim or bezel per your model's service instructions to access the pad cover—use gentle, non-marring tools to avoid scratching surrounding surfaces
• Some pad covers snap into place; others may use adhesive or retainers—retain any original mounting clips or screws for reinstallation
• After installation, restore power and test all buttons and functions before reassembling all trim

Secures the igniter to the burner assembly in gas ranges and ovens. Replace if stripped, missing, or damaged during igniter replacement or repair.