Parts for Thermador PRD48JDSGU/07: Griddle & Element Parts

The Drip Tray is an OEM part for Bosch ranges. The drip tray catches any liquid spills, grease, or condensation generated during the cooking process. Its open design allows easy access for cleaning while contained drainage protects components.

Causes of a faulty drip tray can include cracks or punctures from impact, melting or warping from high heat exposure over time, or general damage during cleaning.

Symptoms of a bad range drip tray include:

• Grease or liquidAccumulation outside of the drip tray area
• Dripping or potential fire hazards if material collects on heating elements below
• Difficulty removing the drip tray for cleaning due to deformities or breaks

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.
 

The Heater Element Range is an OEM component for Bosch electric ranges. It is responsible for generating precise heat to cook foods and bake consistently.

Causes of a bad element range include scaling or mineral deposits from repeated cleanings that interfere with heat transfer. Broken coils from rough handling can also disrupt heat output.

Symptoms of a bad heater element range include:

• Long preheat times unable to reach desired heat  
• Burnt exteriors but raw interiors when baking
• Disabled or reluctant-to-heat oven and broiler functions
• Hot and cold spots causing inconsistent results

This OEM Bosch part can also be used on Thermador and Gaggenau appliances.

This cable harness connects a dishwasher's electrical components to the control board, restoring reliable signal and power routing for proper operation. Designed as a direct-fit replacement to replace damaged or worn wiring. What it does:

• Routes power and control signals between the control board and components such as pumps, valves, or sensors
• Restores intermittent or failed electrical connections caused by frayed wires or broken terminals
• Helps stop issues like controls not responding, lights not working, or certain cycles not starting when the harness is faulty
• Maintains factory routing and connector fit for correct plug-in installation

• One replacement cable harness as shown

• Disconnect power and water before beginning any repair
• Verify connectors match and route wiring according to original harness path; secure with clips or ties as needed
• Handle connectors carefully to avoid bending pins; replace if terminals are corroded or damaged