Parts for Ge AEE18DPM1: 01 - Grille & Chassis Parts

This front case is the exterior face panel that restores the microwave's front appearance and secures the control area and door components. It provides a clean, finished look and replaces cracked, warped, or damaged front panels. What it does

• Covers and protects the control panel, touchpad, and underlying electronics from dirt and impact
• Helps align and secure the microwave door and latch assembly for proper closure
• Restores cosmetic appearance by replacing cracked, scratched, or discolored front housing
• Can stop rattling or vibration caused by a loose or damaged front panel

• One front case (face panel) as shown

• Disconnect power at the breaker before starting and ensure the unit is completely de-energized
• Installation typically requires removing screws, trim pieces, and the door; handle the door and glass carefully
• Keep small fasteners and trim organized; test door alignment and latch engagement after installation

Replacement air guide frame for room air conditioners. Directs airflow through the unit. Order a new frame if yours is cracked, broken, or missing.

Replacement vertical louver link for room air conditioners. Connects and controls the vertical air deflection blades. Order if broken, cracked, or missing.

Air filter assembly for room air conditioners. Traps dust and lint to protect the evaporator coil and maintain cooling performance. Verify fit with model.

Complete outer housing for room air conditioners. Replaces cracked, dented, or rusted cabinets. Encases internal components for protection.

Protective guard that mounts to your air conditioner's front grille. Replace if cracked, broken, or missing to restore proper appearance and protection.

Top guide assembly for air conditioner accordion panels. Secures and aligns side curtains at the top of the unit. Replace if cracked, broken, or missing.

This Form Gasket 2 is a replacement sealing gasket designed to restore a tight, reliable seal where the original foam/form gasket has become compressed or damaged. Replacing it helps reduce leaks and maintain normal appliance operation. What it does:

• Replaces a worn or damaged foam/form gasket to restore proper sealing
• Helps prevent water, air, or debris from passing where the original gasket seals
• Commonly used where a formed seal cushions or closes a gap in the appliance assembly
• Address symptoms such as visible gaps, leaks, rattling, or improper sealing along the joint

• One Form Gasket 2 as shown

• Install in clean, dry area; remove old gasket and clean mating surfaces before fitting the new gasket
• Fit gasket to the formed channel or mounting surface per the appliance's service instructions
• Wear gloves to protect hands from sharp edges and to avoid contaminating the gasket surface

This molded form gasket provides a replacement seal designed to restore a tight closure and reduce air or water leakage. It helps maintain proper appliance operation by replacing a worn or damaged seal. What it does:

• Seals the mating surface to prevent air or water from leaking out
• Helps reduce frost build-up or moisture-related pooling when the seal is compromised
• Restores door/compartment closure where a deformed or torn gasket allows gaps
• Commonly replaced when gasket shows visible cracks, gaps, or continual leaks

• Disconnect power and remove any stored items before replacing the gasket
• Clean and dry the sealing surface thoroughly to ensure a proper fit
• Align the gasket into the channel and press evenly; some trims may require careful seating along the entire edge
• Inspect surrounding trim and hardware; replace or tighten as needed for a complete seal

Installation hardware assembly kit for room air conditioners. Includes mounting brackets and fasteners needed to secure unit in window or wall opening.