Parts for Ge AZ41E12EACW1: 01 - Grille, Heater & Base Pan Parts

This control cover replaces the front cover over a room air conditioner's control panel. It restores a clean, finished look, protects the controls from dust and accidental contact, and helps keep the user interface securely positioned.

• Covers and protects the control board, switches, and display area
• Provides a labeled, easy-to-use interface and clean appearance
• Replaces cracked, broken, or missing covers that can expose wiring or cause rattling
• Helps buttons/knobs align and operate correctly

• Disconnect power and unplug the unit before servicing.
• Access the control area; remove the existing cover and retain screws/fasteners and any knobs as needed.
• Transfer any mounting clips or inserts from the old cover if present.
• Position and secure the new cover; verify the controls move freely and the cover seats properly.

The Air Filter is an OEM replacement part for GE refrigerators. This component plays a crucial role in maintaining air quality and freshness within the refrigerator compartment by trapping odors, pollutants, and airborne particles. It measures about 14-1/2 inches wide by 10 inches high.

Symptoms that may indicate the need to replace the air filter include:

•  Persistent unpleasant odors within the refrigerator
• Reduced air circulation or airflow
• Visible discoloration or clogging of the filter material

Causes of a faulty air filter can include normal wear and tear over time, accumulation of excessive debris or contaminants, or exposure to high humidity or moisture levels.

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore refrigerator models.

This control cover replaces the front cover over a room air conditioner's control panel. It restores a clean, finished look, protects the controls from dust and accidental contact, and helps keep the user interface securely positioned.

• Covers and protects the control board, switches, and display area
• Provides a labeled, easy-to-use interface and clean appearance
• Replaces cracked, broken, or missing covers that can expose wiring or cause rattling
• Helps buttons/knobs align and operate correctly

• Disconnect power and unplug the unit before servicing.
• Access the control area; remove the existing cover and retain screws/fasteners and any knobs as needed.
• Transfer any mounting clips or inserts from the old cover if present.
• Position and secure the new cover; verify the controls move freely and the cover seats properly.

This heater assembly restores the defrost assist function in compatible dehumidifiers, helping clear frost from the coil so the unit can keep removing moisture efficiently. Replacing a failed heater helps prevent freeze-ups and maintain consistent performance in cooler rooms. What it does:

• Provides controlled heat to aid the defrost cycle and melt ice on the evaporator
• Helps maintain airflow and steady water collection in low-temperature conditions
• Common symptoms of failure: persistent coil icing, reduced moisture removal, repeated freeze-ups

• 1 heater assembly

• Disconnect power before servicing and allow components to cool
• Note wire routing and connector positions; transfer any clips/brackets from the old assembly if needed
• Mount in the original location with proper clearances from wiring and plastic parts
• After reassembly, run the unit and monitor for proper defrost operation

This thermostat regulates oven temperature to help maintain consistent cooking heat and proper bake/ broil cycles. It replaces a faulty temperature control to restore accurate oven heating. What it does:

• Senses oven temperature and signals the heating element to turn on or off
• Helps maintain set cooking temperatures for even baking and roasting
• Can stop the oven from reaching and holding the correct temperature when failing
• Common symptom: oven not heating, overheating, or temperature fluctuating during use

• One thermostat assembly

• Disconnect power to the appliance before starting any repair
• Mounts in the oven control area; handle the capillary/tube gently to avoid kinks
• Some installations may require knob removal or access behind the control panel