Parts for Craftsman 917374100: Handle / Engine / Housing Parts

A replacement door switch that senses when the appliance door is closed and allows the unit to operate. Restores normal safety interlock function so the appliance only runs with the door properly shut. What it does

• Detects door closure and completes the circuit to allow the appliance to start or run.
• Prevents operation when the door is open, helping keep users safe.
• Commonly linked to symptoms such as the appliance not starting, stopping mid-cycle, or controls not responding when the door is shut.
• Works as a direct electrical interface for the door latch or catch assembly.

• Disconnect power (unplug or shut off circuit breaker) before accessing the switch.
• Remove required access panels or the door inner panel; handle sharp edges and glass with care.
• Confirm wiring and connector orientation match the replacement; secure all fasteners and reassemble panels fully.

This left-hand adaptor bracket secures and aligns a refrigerator column or trim piece so panels sit flush and stable. It helps restore proper door/trim alignment and reduces rattling or visible gaps for a clean, finished look. What it does:

• Secures the refrigerator column/trim to the cabinet frame for proper alignment
• Helps eliminate loose or misaligned trim that can catch or rattle
• Restores intended panel fit and gap spacing after wear or damage
• Useful when replacing damaged or missing mounting hardware

• Designed for appliance service use; use appropriate fasteners as specified by the manufacturer;
• Disconnect power to the appliance if removal requires accessing electrical components

This small rubber gasket seals and cushions an M4 fastener to help prevent leaks and reduce vibration at attachment points. It's a compact replacement part used where a watertight or vibration-damping seal is needed. What it does:

• Creates a seal around an M4 screw or bolt to help prevent water intrusion
• Cushions fasteners to reduce vibration, noise, and metal-on-metal wear
• Restores a tightened fastener's proper sealing surface when the original gasket is worn
• Helps maintain appliance integrity around panels, brackets, or connections

• Power off and unplug the appliance before starting any repair.
• Confirm the gasket's size matches the fastener and seating area before installation.
• Install flat against the mating surface; tighten fastener snugly but avoid over-torquing which can deform the gasket.
• Handle small parts carefully and retain any removed hardware for reassembly.

This replacement part is an electric key start. This part is able to start and stop the machine during use and when the user prompts. A new electric key start might be needed if the current one is no longer working. Occasionally, the electric start key can become stuck in the equipment and may be damaged upon removal. Be sure the engine is powered off when attempting to replace or remove this key start. This should be an easy repair and only require common household tools, like pliers, at most.This is a genuine replacement part made by Dewalt. It is an OEM replacement part which will ensure a proper fit. This part is sold individually.