Parts for Speed Queen LTSA7AWN4350: Hose Assy Parts

This inlet hose connects the washer's water inlet valve to the tub, routing incoming water to the wash chamber so the machine fills properly. It's a direct-replacement service part for restoring proper water flow. What it does:

• Transfers water from the inlet valve into the washer tub for filling cycles
• Helps ensure correct water supply for wash and rinse operations
• Commonly replaced when leaking, cracked, or collapsed hose restricts fill
• Can resolve symptoms like slow/no fill, visible leaks, or water pooling under the machine

• One inlet hose

• Disconnect power and shut off the water supply before replacing the hose
• Inspect adjoining fittings and clamps; replace clamps if corroded or damaged
• Route hose free of kinks and avoid pinching during reassembly
• If you see continued leaking after install, re-check hose seating and clamp tightness

The Washer Filter is an OEM replacement part for Speed Queen top-loading washing machines. Located at the bottom of the washer tub, this filter traps lint and other debris to prevent plumbing issues. It must be cleaned regularly to maintain optimal water flow.

Symptoms of a clogged or damaged filter include:

• Slow or inadequate water fill levels 
• Cycles taking longer to complete 
• Accumulation of debris in pump/hoses
• Draining or spinning issues

Causes may be related to prolonged use without cleaning, excessive mineral or detergent buildup over time, or physical damage like cracks that allow lint to pass through.

This part is compatible with some Whirlpool, Maytag, and Kenmore-branded top loaders as well.

This water mixing valve controls and blends hot and cold water to deliver the selected fill temperature for the washer, restoring proper wash-temperature control and consistent cycle fills. What it does

• Mixes incoming hot and cold water to achieve set wash temperature.
• Directs water flow to the tub during fill cycles.
• Can cause inconsistent or incorrect water temperature when faulty.
• May leak or prevent proper filling if worn or damaged.

• One water mixing valve assembly.

• Disconnect power and shut off both hot and cold water supplies before servicing.
• Drain remaining water from hoses and system to avoid spills during replacement.
• Replace with the exact valve assembly and tighten clamps to manufacturer torque recommendations.
• Test cycles for correct water temperature and check for leaks after installation.