Parts for Speed Queen LTSA9AWN: Hose Assy Parts

This small sealing washer fits the washer's water pressure assembly to help maintain a proper watertight seal at the pressure/valve connection. Replacing a worn washer reduces leaks and helps the fill/pressure system operate as intended. What it does

• Provides a watertight seal at the water pressure/valve connection to prevent leaks.
• Helps maintain correct pressure feedback to the washer's water control system.
• Wear or damage can allow leaking at the valve or inconsistent fill behavior.
• Simple, low-cost part commonly replaced when troubleshooting valve leaks.

• Turn off household water supply and unplug the washer before replacing.
• Remove the valve/pressure fitting carefully and replace the old washer with the new one, making sure it seats flat and undamaged.
• Inspect mating surfaces for debris or damage; clean before reassembly.
• If leaks or fill issues persist after replacement, inspect related seals, fittings, and the pressure switch/valve assembly.

The Washer Filter is an OEM replacement part for Speed Queen top-loading washing machines. Located at the bottom of the washer tub, this filter traps lint and other debris to prevent plumbing issues. It must be cleaned regularly to maintain optimal water flow.

Symptoms of a clogged or damaged filter include:

• Slow or inadequate water fill levels 
• Cycles taking longer to complete 
• Accumulation of debris in pump/hoses
• Draining or spinning issues

Causes may be related to prolonged use without cleaning, excessive mineral or detergent buildup over time, or physical damage like cracks that allow lint to pass through.

This part is compatible with some Whirlpool, Maytag, and Kenmore-branded top loaders as well.

This water mixing valve assembly controls and blends hot and cold water during washer fill cycles to help achieve the selected wash temperature. Designed as a direct replacement valve for affected Speed Queen top-load and commercial washers. What it does

• Directs and mixes incoming hot and cold water to regulate fill temperature.
• Helps the washer reach and maintain the selected wash temperature for proper cleaning.
• Common symptom: washer fills with only hot or only cold water or delivers inconsistent water temperature.
• Can cause extended fill times or temperature-related cycle issues when failing.

• Disconnect power and shut off water supply before beginning replacement.
• Turn off and drain inlet hoses to avoid water spills; have towels or a bucket ready.
• Basic hand tools required; follow OEM service manual for proper disassembly and reassembly.
• Inspect inlet hoses and seals; check for leaks and test a full cycle after installation.