Parts for Weedeater WM5N21SA: Housing / Handle / Engine / Wheels Parts

This replacement part is a guide kit. This is a genuine replacement part made by Husqvarna. Guide kits are small parts that connect to the side of a lawnmower to help the user create clean lines during use. The rope is looped through the guide so that the user maintains consistent work. A new guide kit might be needed if the user is unable to maintain clean lines while cutting grass. If the guide loop is worn down and will not hold rope correctly, it might be time to replace the guide kit. This repair should be fairly simple and only require common household tools such as a screwdriver and perhaps pliers if the previous piece is stuck. This is a genuine OEM replacement part. This part is sold individually and is sourced directly from the manufacturer to ensure proper fit.

Replacement handle bolt for lawn mowers and outdoor power equipment. Secures upper and lower handles together. Replace if damaged, stripped, or missing.

This is an engine zone control cable, also known as a control cable, manufactured by Husqvarna. This component stops the blade when a lawn mower handle is released. When this part goes bad, it can cause the brake not to release even when the handle is pressed down. Engine zone control cables are known for experiencing wear and tear with regular use. If the cable has any signs of damage, cracking, wear, or stretching, it will need to be replaced. First, disconnect the spark plug wire before releasing the cables from the handle. Next, remove the drive cover before removing the engine zone control cable. The replacement engine zone cable can be connected to the transmission and the drive cover can be replaced. Install the control cable back onto the mower handle, reconnect the spark plug wire, and the lawn mower will be usable again. This is a genuine OEM replacement part that comes directly from the manufacturer. It can be used for mowers from Husqvarna, Weed Eater, AYP, Craftsman, RedMax, Poulan, Poulan Pro, Jonsered, and McCulloch. It is sold individually, and the replacement is considered easy. A screwdriver and pliers are the only tools that will be needed.

Handle knob for lawn mowers, snowblowers, and trimmers. Attaches to upper or lower handle adjustment levers. Replace when cracked, broken, or missing.

Hairpin cotter pin clip secures components on shafts in walk-behind lawn mowers. Replace if bent, broken, or missing to properly retain parts.

Height adjustment bracket for walk-behind mowers. Mounts to deck to enable cutting height changes. Replace if bracket is bent, cracked, or broken.

Spring for walk behind lawn mowers. Small metal component that provides tension for engine and operating parts. Replace if broken, stretched, or missing.

Attaches to the height adjuster lever to set your mower deck cutting height. Replace if cracked, broken, or missing for proper deck adjustment control.

Flanged hex nut for lawn tractors and outdoor power equipment. Replace if threads are stripped, nut is missing, or hardware has corroded or loosened.

Secures hinged components on your walk-behind lawn mower. Replace if screw is stripped, missing, or damaged. Essential hardware for proper assembly.

Left-hand spring for walk behind lawn mowers. Replace if your original spring is stretched, broken, missing, or no longer provides proper tension.

Uneven lawn cuts or poor mulching? This walk-behind mower blade restores clean cutting performance. Simple DIY replacement in under 30 minutes.

Rear grass catcher frame mounts on the back of your walk behind lawn mower to support the grass bag. Replace if cracked, bent, damaged, or missing.