Parts for Weedeater 2595: Housing / Motor Parts

This authentic OEM replacement wire harness is an assembly of various wires needed to operate a leaf blower engine. Leaf blowers have many parts that send an electrical current to create the desired effect—for example, the throttle. This current travels through a wire and switch to generate a response. If the wires become damaged, they will no longer transfer a signal. This harness is a replacement set containing a switch, cables, and terminals. One of the most common causes of damaged wiring is overheating. If the electrical current traveling through the wires suddenly fluxes, the wires can be fried, causing the leaf blower to stop functioning. When this happens, the wires will have to be replaced before the blower can be used again. This is a straightforward repair and will only require a screwdriver. Be sure to follow the user's manual and make note of where each wire goes. This is a high-quality replacement part sourced from the original manufacturer and is designed to be used with Weed Eater, Paramount, Poulan Pro, Husqvarna, and Craftsman leaf blowers. It ships separately of any additional hardware.

This is a replacement bag that is used on leaf blowers from a variety of brands. The grass catching bag is used to catch grass and clippings, making it possible to reduce the amount of raking and cleaning up that needs to be done after using the blower when it is vacuum mode. Once the bag is full, unzip it and pour the contents into your container for garden waste or use it for mulch. While blowers will typically come with a bag, they may wear out over time or become damaged. Eventually, it will need to be replaced with a high quality, OEM replacement bag. This part is sourced from Husqvarna, which helps to ensure it will fit properly and will be high-quality. This Bag Blr Vac'n' sac will work with a range of different brands of blowers, including Husqvarna, Paramount, and Weed Eater.

This part is a vacuum tube set that is used on outdoor power equipment blowers and vacuums. The vacuum tube is the component that directs the leaves and debris into the vacuum bag. The vacuum tubes are manufactured out of a hard plastic material.A new vacuum tube set will be needed if they are cracked, broken, or damaged in any way. This damage could be a result of direct impact with a hard object. The vacuum tube set may be needed to replace parts worn due to normal wear and tear over time. No tools are required to install the vacuum tubes. Remember to wear gloves when operating or performing care and maintenance on any outdoor power equipment.This vacuum tube set is a genuine Husqvarna part. It is sold individually. This particular vacuum tube set is compatible with outdoor power equipment blowers and vacuums that are manufactured by Husqvarna and Craftsman.

This OEM replacement part is an inlet restrictor tube for leaf blowers. The inlet restrictor fits into the air inlet and is used to improve blower function. If the leaf blower is no longer functioning like it used to and is struggling to maintain its power, it might be time for a new inlet restricor tube. While this might seem like a difficult repair, replacing this part is actually a very simple process.To replace the inlet restrictor tube, make sure the engine is cool and the on off switch is in the off position. Remove the main tube from the leaf blower. Then locate the inlet restrictor tube at the base of the leaf blower. Using a flathead screwdriver, pry off the old inlet restricor tube and set it to the side. Slide the new tube into place and reinstall the main tube. This genuine OEM part is compatible with Husqvarna leaf blowers.